Table of Contents
Related Manuals for Coast Spas EcoClean ST1
Summary of Contents for Coast Spas EcoClean ST1
- Page 1 Coast Spas Manufacturing Inc. EcoClean Owner’s Manual Salt Chlorinating System for residential spas The natural alternative to maintaining clean and clear water in your spa MODEL ST1 REGISTRATION NUMBER 27899.02 PEST CONTROL PRODUCTS ACT.
-
Page 2: Table Of Contents
TABLE OF CONTENTS Introduction & Important Safety Instructions Health General Hyperthermia & Important Information Specifications Spa Water Preparation & Monitoring Boost Option Power Supply & Cell Installation Diagram Trouble Shooting Page 1 ... -
Page 3: Important Safety Instructions
INTRODUCTION Congratulations! You have purchased a Coast Spa with EcoClean system one of the most technologically advanced spa sanitation systems in the world. IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS EQUIPMENT RELATED, INSTALLATION AND GENERAL USE: Installation of all EcoClean models When installing and using the EcoClean unit, basic safety precautions must always be followed, including the following: WARNING –... -
Page 4: Health
HEALTH 1. People using medication and/or having an adverse medical history should consult a physician before suing a spa or hot tub. 2. People with infectious diseases should not use a spa or hot tub. 3. The maximum spa water usage temperature is 40°C (104°F). Duration in spa water at 40°C (104°F) should not exceed 15 minutes. -
Page 5: General
GENERAL WARNING – To reduce the risk of injury do not permit children to use this product unless they are closely supervised at all times. Children should not use spa or hot tub without permanent adult supervision. WARNING – Risk of Accidental Drowning. Extreme caution must be exercised to prevent unauthorized access by children. - Page 6 HYPERTHERMIA WARNING – The use of alcohol or drugs can greatly increase the risk of fatal hyperthermia in hot tubs and spas. Consult your spa/hot tub manufacturer’s manual for the proper adjustment of water temperature. Prolonged immersion in hot water may induce hyperthermia. Hyperthermia occurs when the internal temperature of the body reaches several degrees above the normal body temperature of 37°C (98.6°F).
-
Page 7: Specifications
Manually balance the spa water chemistry to meet all suggested ranges of water balance factors listed below before startup of the EcoClean unit. Fill your Coast Spa following instructions in your Coast Spas Owner’s Manual.Upon a fresh fill of the spa you need to perform the following steps: 1) Completely balance the spa’s water (as if there was no Eco Clean installed) - Page 8 You need to ensure that the salt that you are using does not contain any Iodine or YPS. Chemicals can be obtained from any Coast Spas authorized Dealer. At this point you will add the salt to the water when pumps are running. You want to have between 2200ppm –...
-
Page 9: Boost Option
BOOST OPTION There is also a “BOOST” button on the system. This feature should only be used when there is a large increase in usage. If the bather load is 2 people twice a week and you end up having 8 people use it on a Friday night, then it is suggested that the “BOOST”... -
Page 10: Troubleshooting
TROUBLESHOOTING PROBLEM CAUSE SOLUTION The test kit reagents or test strips are old or expired. Retest with new reagents or test strips. Insufficient sanitizer The unit is set too low in relation to the sanitizer de- Increase the feed rate on the output dial. production.
Need help?
Do you have a question about the EcoClean ST1 and is the answer not in the manual?
Questions and answers