For the latest information, always consult the current PIONEER Service Manual. A subscription to, or additional copies Also test with plug reversed of, PIONEER Service Manual may be obtained at a (Using AC adapter Earth nominal charge from PIONEER. plug as required)
Page 3
By following the instructions in this manual, be sure to apply the prescribed grease or glue to proper portions by the appropriate amount.For replacement parts or tools, the prescribed ones should be used. S-VW02...
RCA plug cord x 1 Non-slip pads (1x4) Operating instructions x 1 NOTE: Specifications and design subject to possible modification without notice, due to improvements. Accessories • Power cord • Non-slip pads • RCA plug cord (ADG1158) (SEC1563) (SDE1031) (for Subwoofer) S-VW02...
Screws adjacent to mark on product are used for disassembly. For the applying amount of lubricants or glue, follow the instructions in this manual. (In the case of no amount instructions, apply as you think it appropriate.) 2.1 PACKING S-VW02...
Page 7
(English, Spanish, Chinese) Polyethylene Bag SHL1291 NSP 7 Accessary Set SEA1619 > Power Cord ADG1158 RCA Plug Cord SDE1031 Non Slip Pads SEC1563 Polyethylene Bag SHL1294 • • • • • • • NSP 13 Polyethylene Bag SHL1212 Protector SHB1121 S-VW02...
Page 13
LED ASSY (AWU8140) FRONT ASSY (AWU8139) REK1026 REK1026 REK1026 BKP1046 ADG1158 SW ASSY(AWU8141) Note : When ordering service parts, be sure to refer to "EXPLODED VIEWS and PARTS LIST" or "PCB PARTS LIST". S-VW02...
3.4 PRIMARY M and UFS2 ASSYS • NOTE FOR FUSE REPLACEMENT CAUTION - FOR CONTINUED PROTECTION AGAINST RISK OF FIRE. REPLACE WITH SAME TYPE AND RATINGS ONLY. CN3051 CN3312 CN3303 S-VW02...
Symbol In PCB Symbol In Schematic Part Name Diagrams Diagrams C E B Capacitor Connector Transistor B C E SIDE A Transistor with resistor B C E Field effect SIDE B Chip Part P.C.Board transistor Resistor array 3-terminal regulator S-VW02...
IC42 W139 W141 Q3307 W137 INSIDE IC31 BOND PRINTED R3325 SIDE BOND IC31 W134 W133 BOND IC32 IC32 12AC 12GND 12AC POWER AC POWER AC POWER CENTER BOND POWER CENTER POWER AC POWER AC RIVET BOND CN3303 (ANP7467-B) CN8303 S-VW02...
Page 22
D3605 R3619 D3601 C3364 +OUT D3604 C3361 R3610 R3601 AC DET SP RY IC31 IC32 POWER SUPPLY 12AC 12GND 12AC AWU8129 AWU8130 AWU8131 AMP ASSY AWU8132 POWER AC POWER AC POWER CENTER POWER CENTER POWER AC POWER AC (ANP7467-B) S-VW02...
SIDE A SIDE A FRONT ASSY VR3171 VR3151 CN8111 CN8113 C3181 C3182 C8111 CN3151 Production Code (ANP7468-B) CN3151 CN8351 SW ASSY LED ASSY AWU8140 PRIMARY CN8112 AWU8141 PNE-1B1 (ANP7468-B) (ANP7468-B) CN8112 CN8221 CN8211 C D E C D E S-VW02...
Page 26
SIDE B SIDEB FRONT ASSY Q3151 IC3151 IC3151 R9302 Q8112 Q8111 R9305 CN3151 (ANP7468-B) CN8111 SW ASSY LED ASSY AWU8140 PRIMARY PNE-1B1 ASSY PNE-1B1 AWU8141 CN8112 (ANP7468-B) C D E C D E S-VW02...
AND RATINGS OF FUSE W117 W116 ATTENTION REMPLACER PAR LE FUSIBLE PAR UN MODELE INDENTIQUE EN INTENSITE W114 W111 W110 W113 BOND W112 W109 BOND W108 W107 W106 PRODUCTION CODE W101 W103 W102 SECONDARY CN82 (ANP7469-B) IC81 CN8204 CN8203 S-VW02...
Page 28
SIDE B SIDEB PRIMARY M ASSY PNE-1B1 PRIMARY CUSHION SECONDARY (ANP7469-B) IC81 S-VW02...
GNDA SIGNI VA+12 GNDA VA-12 VE+5V GNDD P-ON SECONDARY W132 SIGNO SUBAC GNDA VE+5V SIGNI GNDD VA+12V P-ON GNDA VA-12V W119 SUBAC VE+5V GNDD P-ON CENT CENT PRIMARY 12VAC 12VCENT 12VAC P AC P CENT P AC PRIMARY (ANP7469-B) S-VW02...
Page 30
VA-12V VE+5V GNDD P-ON SIGNO SUBAC GNDA VE+5V SIGNI GNDD SECONDARY VA+12V P-ON GNDA VA-12V SUBAC VE+5V GNDD P-ON 12VAC 12VCENT 12VAC P AC P CENT P AC 12VAC 12VCENT 12VAC P AC P CENT P AC RIVET (ANP7469-B) S-VW02...
The front panel is attached to the baffle by press-fitting. To detach it, pry it open by inserting a flat blade screwdriver into lower side. Pull out the front panel loosing the packing around the duct and inside panel and the wire styling. S-VW02...
Page 35
10) Remove the UFS2 ASSY disconnecting 2 board to board connectors between the UFS2 ASSY and the AMP ASSY. 3 ) Unfasten 6 screws 3 attaching left and center side of the rear panel. Disconnect the fan cable. 4 ) Remove the rear panel. AMP ASSY S-VW02...
Packing (SEC1712) Power Knob Acetate Tape * Countermeasure (SEH1050) for the resonant vibration (3.5×8.5mm) FRONT ASSY PRIMARY M ASSY PRIMARY M ASSY Acetate Tape * Countermeasure for the resonant vibration Voltage Selector Acetate Tape * Countermeasure for the resonant vibration S-VW02...
Page 37
Caution for Cable Styling Amplifier Module Wire Tie 90mm(SEP1003) Cable Clamper(SNE1022) Cable Holder(Twist Lock) for the cable from the Transformer Cable Holder(Twist Lock) for the cable from the Power SW Cable Holder(Twist Lock) for the cable from the FRONT ASSY S-VW02...
7.3 CLEANING Before shipping out the product, be sure to clean the following positions by using the prescribed cleaning tools: Position to be cleaned Cleaning tools Fans Cleaning paper : GED-008 S-VW02...
180° and set the switch in the position where the sound is natural. 8 AC INLET • Connect the power cord to the powered subwoofer unit’s AC INLET. • Connect the power cord to a AC socket. S-VW02...
Need help?
Do you have a question about the S-VW02 and is the answer not in the manual?
Questions and answers