Insert Editing - JVC DF450 - Camcorder - 680 KP Instructions Manual

Insert Editing

You can record a new scene into a previously
recorded tape, replacing a section of the original
recording with minimal picture distortion at the in
and out points. The original audio remains
unchanged.
Use the provided remote control.
NOTES:
Before performing the following steps, make sure
that "TIME CODE" for "CAMERA DISPLAY" and
"VIDEO DISPLAY" is set to "ON".
( pg. 36, 39, 41)
Insert Editing is not possible on a tape recorded in
the LP mode or on a blank portion of a tape.
1
Play back the tape, locate the Edit-Out point
and press PAUSE (9). Memorize the time code
at this point ( pg. 21) since it will be needed to
5.
stop editing in step
2
Press REW ( ) until the Edit-In point is
3
located, then press PAUSE (9).
3
Press and hold INSERT (I) on the remote
control, then press PAUSE (9). The "9I"
indicator and the Time Code (min.:sec.) appear
and the camcorder enters Insert-Pause mode.
4
Press START/STOP to begin editing.
To pause editing, press START/STOP. Press it
again to resume editing.
5
When the time code reaches Edit-Out point
(time code from step
then STOP (8) to end Insert Editing.
NOTES:
Program AE with special effects (
be used to spice up the scenes being edited
during Insert Editing.
During Insert Editing, the date and time
information changes.
If you perform Insert Editing onto a blank space on
the tape, the audio and video may be disrupted.
Make sure you only edit recorded areas.
During Insert Editing, when the tape moves to
scenes recorded in the LP mode or a blank
portion, Insert Editing stops. (
1
), press START/STOP,
pg. 47) can
pg. 59)
EDITING
55
EN