Endon CLEF-BAR-3CH Instruction Manual

Safety Warnings
This product is only suitable for connection to a 240V~50Hz supply in accordance with current IEE
wiring Regulations and should be installed in accordance with local Building Regulations and is for
Domestic indoor ceiling use only - and is not suitable for a Bathroom location.
The light fitting should be connected to a lighting circuit protected by a 5 amp fuse (or a 6 amp
miniature circuit breaker).
If in doubt we recommend you contact a qualified electrician. Before installing your light fitting
always:
Switch off the mains supply and remove the appropriate fuse or switch off the appropriate circuit
breaker before commencing installation.
Ensure that no one else has access that would enable the supply to be inadvertently reconnected.
Never fit bulbs of a higher wattage or of a type other than those specified on the label as this may
cause overheating and damage the fitting.
This product contains glass parts – be careful during handling and maintenance to avoid breakage.
The bulbs become hot during use so please switch off and allow 10 minutes to cool before replacing
bulbs or cleaning the fitting.
Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product.
This fitting is heavy and you may require assistance in connecting it to the supply and securing it to
the mounting surface.
The "Minimum Distance" Label – typical format shown below – indicates that lighted objects should
not be placed within the distance stipulated on the label. The example label below indicates that
lighted objects should not be placed within 0.5m (50cm) of the spotlight to prevent them
overheating.
If any modification is made it will invalidate the warranty and may render the product unsafe.
Please read these instructions carefully before fitting your new light and retain for reference.
Make sure that there are no pipes or cables beneath the mounting surface.
Check the packaging and make sure that you have all the required parts.
Follow each assembly step in order to prevent incorrect assembly.
Make sure all screws / nuts, including electrical connections etc are fully tightened before use.
This type of Light Fitting may be connected to a Dimmer but seek advice before
The Light pack contains:
Light fitting and mounting bracket.
Terminal connection block(s)
Allen Key.
CLEF-BAR-3CH
INSTRUCTION MANUAL
0.5m
Before you start
The following tools may be required:
Selection of cross and flat head screwdrivers.
Electric drill and assorted drill bits.
Wire strippers.
Electrical insulation tape.
1
purchase,