Endon Joshua Instruction Manual

Safety Warnings

• This product is only suitable for connection to a 240V~50Hz supply in accordance with current IEE wiring
regulations. It is for indoor use only, and not suitable for a bathroom location.
• This fitting is a Class II, Double Insulated product
be connected to Earth.
• Do not plug into the mains until your lamp is fully assembled.
• When used as a table lamp, under no circumstances must this product be covered with any material as this
could pose a safety hazard. It must be used on a stable, flat surface.
• Never fit bulbs of a higher wattage than those specified on the label, as these may damage the fitting.
• The lamp must be protected by a 3 amp fuse in the mains plug.
• If the mains cable becomes damaged it must only be replaced by a technically competent, qualified person.
• If you are in any doubt about your competence please consult a qualified electrician.
• This product contains delicate parts – take care during handling and maintenance to avoid breakage.
• If any modification is made it will invalidate the warranty and may render the product unsafe

Care Information

Allow 10 minutes to cool before replacing, adjusting or cleaning.
Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product.

Assembly/ User Instructions

Please read these instructions carefully before fitting and retain for reference. Check the packaging and make
sure that you have all the required parts. Follow each assembly step in order to prevent incorrect assembly.
Ensure that the product is fully assembled as illustrated before use.
These assembly diagrams are intended as a guide – if in doubt consult a qualified electrician.

If used as a table lamp

Endon Lighting, LS9 0SE
Joshua Table and Wall Light
INSTRUCTION MANUAL
Before you start
1. Do not attempt to plug in or use this product until it has been
fully assembled. Disconnect from mains during assembly
or maintenance.
2. Carefully unpack your lamp, and place on a stable, flat surface.
3. Install the bulb (1). Do not install a bulb with a greater wattage or
different shape than specified on the label.
4. Plug in, and operate the rocker switch (2) to turn your lamp on.
5. This product has a USB socket - further details are shown overleaf.
If your lamp will not illuminate, please check the bulb, the 3 amp
fuse in the plug and ultimately check the
relevant fuse in your Fuse Box.
If unsuccessful please consult
your Retailer.
and does not require an Earth. Live or Neutral must not
77991_80645 Joshua W-TL 20190612
E
Fuse
(3 AMP)
L
N
Brown
Blue
(Live)
(Neutral)
Class II Plug Wiring Diagram