Endon Leyton Instruction Manual

Assembly/ User Instructions

Please read these instructions carefully before fitting your new light and retain for reference.
This pack contains:
1x Table Lamp with a head adjustable for angle

Safety Warnings

Do not plug into the mains until you have installed a correct bulb.
This product is only suitable for connection to 240V~50Hz supply and is not suitable for a Bathroom location.
The Table Lamp must be protected by a 3 amp fuse in the mains plug.
The Class II, Double Insulated symbol
Neutral must not be connected to Earth.
If any modification is made it will invalidate the warranty and may render the product unsafe.
If the mains cable becomes damaged it must only be replaced by a technically competent, qualified person.
If the mains plug requires replacing use a plug approved to BS1363 with 3 Amp fuse and wire it up according to the
diagram below; Class II (Double Insulated)
If there is a "Minimum Distance" Label, please do not allow Flammable Materials to rest within that distance from the
bulb(s). Never cover any lamp with any object or material.
The shade becomes extremely hot, so please allow to cool before adjusting the angle of the head.
Assembly/ User Instructions
1. Completely unpack your Table Lamp, removing any transit packaging.
2. Install the bulb (1), do not install bulbs with a greater wattage or different shape than specified on the label.
3. Energy saving replacement bulbs: this lamp is suitable to use these lamps.
4. Plug in and turn on the in line switch to try your lamp.

Care Information

If your Table Lamp will not illuminate, please check the 3 amp fuse in the plug and ultimately check the
relevant fuse in your Fuse Box.
If unsuccessful please consult your Retailer.
All Table Lamps for UK Market are designed for 240V ac, 50 Hz (220- 240V ac)
Please retain these instructions for future reference.
Switch off, remove plug and allow 10 minutes to cool before adjusting head, replacing bulb or cleaning using
only a dry cloth.
Leyton Table Lamp
INSTRUCTION MANUAL
For Indoor use only
is on the Lamp so the Lamp does not require an Earth and Live or
Minimum Distance: This is
the symbol which denotes
this requirement.
1
Tools required: none except if replacing plug:
Small electrical screw driver
Distance