Page 1
User Manual Blood Pressure Monitor Model:TMB-2287-B Arm Type Thank you very much for selecting TRANSTEK Blood Pressure Monitor TMB-2287-B. Guangdong Transtek Medical Electronics Co., Ltd. Zone A, No.105 ,Dongli Road, Torch Development District, Please do read the user manual carefully and thoroughtly so as to ensure...
CATALOGUE Table of Contents INTRODUCTION........................2 General Description Indications for Use Measurement Principle Receiving and Inspecting your Monitor Safety Information LCD Display Signal Monitor Components List BEFORE YOU START......................8 Choice of Power Supply Installing and Replacing the Batteries Setting Date and Time Pair a smart device with the monitor Setting a user ID MEASUREMENT........................15...
The monitor features blood pressure measurement, pulse rate measurement They are the requirement of standard and using. and the result storage. The warranty period is two years. Readings taken by the TMB-2287-B are equivalent to those obtained by a Type BF applied part Recyclable trained observer using the cuff and stethoscope auscultation method.
Page 4
INTRODUCTION INTRODUCTION Precaution Warning * This device is intended for indoor, home use and is not intended for self-use in public areas. * This device is portable, but it is not intended for use during patient transport. * Do not apply the cuff on an arm that has an intravenous drip or a blood transfusion attached. * This device is not suitable for continuous monitoring during medical emergencies or operations.
Blood pressure Indicate the blood pressure level. 1. Blood Pressure Monitor 2. Cuff (Type BF applied part level indicator (TMB-2287-B Upper arm cuff:22-32cm or Current Time Year/Month/Day, Hour/Minute Upper arm cuff:22-42cm or Start measurement and save the...
BEFORE YOU START BEFORE YOU START Choice of Power Supply Setting Date and Time 1 .Battery powered mode: It is important to set the clock before using your blood pressure 6VDC 4×AAA batteries monitor, so that a time stamp can be assigned to each record that AC adapter 2 .AC adaptor powered mode: is stored in the memory.
Page 7
BEFORE YOU START BEFORE YOU START BEFORE YOU START 3. When you get the right year, press “START•STOP” button 5 .Repeat the same steps to set the time format between 24H and 12H. to set down and turn to next step. the date format between Repeat the same steps to set [month/day] and [day/month].
2. Interference may occur in the vicinity of equipment marked with the following symbol When the monitor is off, press and hold the “MEM” button to start And TMB-2287-B may interfere the vicinal electrical equipment. pair-up, the bluetooth symbol will flash.
MEASUREMENT BEFORE YOU START Applying the cuff Setting a user ID Only use a cuff that has been approved by the manufacturer for this device model. Before use, please confirm if it fits your arm circumference. There are 2 user ID available.
MEASUREMENT MEASUREMENT MEASUREMENT Start the Measurement Note: 1 .When the monitor is off, press “START•STOP ” button to turn on the monitor, Any time, to stop the measurement, press “START•STOP ” button. and it will finish the whole measurement. (Take User A for example. If you don’t pair with the device or don’t keep the app ON, the bluetooth symbol will flash during the measurement.
MEASUREMENT DATA MANAGEMENT Recall the Records About the irregular pulse rate and excessive body motion during the When the monitor is off, press “MEM” button, the user ID will blink. measurement. You can switch “USER” button to select the user ID between user During a measurement, If an irregular pulse rate is detected, the symbol press “START•STOP”...
DATA MANAGEMENT DATA MANAGEMENT Delete the Records B: To delete all measurements: If you did not get the correct measurement, you can delete 1. Enter the memory recall mode as described in section [Recall the results by following steps below. Records].
INFORMATION FOR USER INFORMATION FOR USER Tips for Measurement Maintenance In order to get the best performance, please follow the instructions below. 1. Cleaning Process: Step 1: Make sure to switch off and unplug the device prior to cleaning. Step 2: Use a soft cloth wetted with soapy water to clean the cuff first, and then use a soft cloth wetted with clear water to remove residual soap until there is no visible residual contaminants.
ABOUT BLOOD PRESSURE ABOUT BLOOD PRESSURE What are systolic pressure and diastolic pressure? Why does my blood pressure When ventricles contract and pump blood out of the Systolic Diastolic fluctuate throughout the heart, the blood pressure reaches its maximum value blood discharging blood entering vein...
SPECIFICATIONS TROUBLESHOOTING Battery powered mode: 6VDC 4*AAA batteries If any abnormality arises during use, please check the following points: AC adaptor powered mode: Power supply (Please use the AC adapter which is authorized by the manufacturer! PROBLEM SYMPTOM CHECK THIS REMEDY Display mode Digital LCD V.A.60.5 mm ×...
Clinical validation: Mean difference within ±5mmHg; Standard deviation 8mmHg Adapter Type: BLJ06L050100U-U The Basis Safety of the Blood Pressure Monitor (TMB-2287-B is as following: Deviation from normal operation that poses an unacceptable risk to the patient or operator. Input: 100-240V, 50-60Hz, 0.2A max 1000 mA Output: Warning: Don’t be near the active HF surgical equipment and the RF shielded room of an ME...
Page 17
EMC GUIDANCE EMC GUIDANCE Table 2 Technical description: Guidance and manufacturer’s declaration – electromagnetic Immunity 1. all necessary instructions for maintaining BASIC SAFETY and ESSENTIAL PERFORMANCE with regard to electromagnetic disturbances for the expected lifetime. IEC 60601-1-2 Immunity Test Compliance level Test level 2.
EMC GUIDANCE EMC GUIDANCE FCC Statement Table 3 Guidance and manufacturer’s declaration - electromagnetic Immunity FCC ID: OU9-TMB2287B IMMUNITY Radiated RF Compliance Test Band Service Modulation Modulation Distance This device complies with Part 15 of the FCC Rules. Operation is subject to the TEST level IEC61000-4-3...
Need help?
Do you have a question about the TMB-2287-B and is the answer not in the manual?
Questions and answers