Page 2
The appliance was designed and made in accordance with the European standards listed below: => EN 30-1-1, EN 30-2-1 and EN 437 plus subsequent amendments (gas) => EN 60 335-1 and EN 60 335-2-6 (electrical) plus relative amendments appliance complies with the prescriptions of the European Directives as below: =>...
ASSISTANCE AND SPARE PARTS Before this appliance left the factory it was tested and set by specialized, expert personnel in order to guarantee the best functioning results. Any subsequent repairs or adjustments that may be necessary must be done with the maximum of care and attention by authorised personnel.
IMPORTANT NOTES AND PRECAUTIONS FOR USE removed from the outer surfaces and You have purchased one of our the various inner parts, thoroughly products for which we thank you. We check that the appliance is in perfect are confident that this new appliance, condition.
Page 5
IMPORTANT NOTES AND PRECAUTIONS FOR USE • The oven door glass and the temperature for two hours. This will accessible parts will become hot allow the protective coating on the when in use. To avoid burns and interior of the oven to be burnt off scalds young children should be and dissipate the associated smells.
Page 6
IMPORTANT NOTES AND PRECAUTIONS FOR USE EN • turn the appliance off and switch off The appliance is not intended to be the electrical supply and do not tamper operated by means of an external with it. All repairs or adjustments must timer or separate remote-control be carried out with maximum care and system...
DESCRIPTION OF THE APPLIANCE PRESENTATION Our cooker is fitted with a fully gas hotplate. The burners are equipped with safety thermocouples. Each knob on the front panel has a diagram printed above it showing to which burner or hotplate it refers. The combination of the different sized burners offers the possibility of various types of cooking.
Page 8
DESCRIPTION OF THE APPLIANCE DESCRIPTION OF HOB CONTROLS GAS BURNER KNOB (A) Press and turn the knob, the following functions appear • = Closed position = “Full on” position = “Reduced rate or Low” position OVEN THERMOSTAT KNOB (B) Press and turn the knob, we will find the different oven temperature values (from 50°C to Max).
Page 9
DESCRIPTION OF THE APPLIANCE BACK-LIGHT INDICATING OVEN ELECTRICAL COMPONENTS ACTIVATION If present, when lit, it indicates that an electric component is inserted LED OR BACK-LIGHT INDICATING THERMOSTAT ACTIVATION When lit it indicates that the oven or the grill is in use. During cooking time the led turns off each time the temperature set is reached.
DESCRIPTION OF THE APPLIANCE ELECTRONIC PROGRAMMER « Model EKK945ABOX only». The programmer can select the following functions: - Clock (set by keys 2 and 3) - Minute counter (set by key 1) - Cooking time (set by key 2) - End of cooking...
INSTRUCTIONS FOR THE USER HOB: GENERAL NOTES ON SAFETY LIGHTING THE BURNERS • When using the burners, do not leave the appliance unsupervised. Ensure that children do not play with Manual ignition the appliance. In particular, make sure that pan Press turn counterclockwise...
Page 12
INSTRUCTIONS FOR THE USER OVEN: GENERAL NOTES ON SAFETY • Do not leave the oven unattended during baking. Ensure that children do not play with the appliance. • Always keep the appliance lid open when using the oven, in order to prevent overheating. •...
INSTRUCTIONS FOR THE USER HOW TO USE THE MULTIFUNCTION OVEN DEFROSTING + WARM UP BY HOT AIR Turn the selector knob to the symbol and adjust the DEFROSTING AT ROOM TEMPERATURE thermostat knob to the desired temperature, then Turn the selector knob to the symbol and place the place the food inside the oven.
Page 14
INSTRUCTIONS FOR THE USER Automatic electric ignition of the gas grill burner HOW TO USE GAS OVEN AND ELECTRIC GRILL Open the oven door push lightly the oven knob and turn The oven burner is fitted with a safety clockwise to the grill position , then depress the thermocouple so, once the burner has been lit, knob.
Page 15
INSTRUCTIONS FOR THE USER USEFUL COOKING TIPS Meat: • If, when cooking meat, the time needed is more than 40 minutes, turn the oven off 10 minutes before Cakes and bread: the end of cooking time to exploit the residual heat •...
Page 16
INSTRUCTIONS FOR THE USER COOKING / BAKING TIMETABLE COOKING BY COOKING BY FORCED CONVECTION Weight NATURAL CONVECTION Position of the oven (WITH FAN) FOODS shelf from the bottom Temperature Cooking Time Temperature Cooking Time in °C in minutes in °C in minutes MEAT LOAFS Roasted Veal...
INSTRUCTIONS FOR THE USER CLEANING AND MAINTENANCE OVEN CAVITY The oven cavity should be cleaned after each use to • Prior to any maintenance work or cleaning, remove cooking residuals and or grease or sugar which, disconnect the appliance from the electricity mains. if burnt on when the oven is used again, will form deposits •...
Page 18
INSTRUCTIONS FOR THE USER OVEN DOOR REMOVAL (fig.11) The oven door can be removed to give easier access to the oven when cleaning. To remove, proceed as follows: • Open the oven door and insert rivet or nail (R) in the hole (F) of the hinge (fig.
TROUBLESHOOTING Some problems can be caused either as the results of simple maintenance operations or by incorrect selection of settings. Prior to contacting a Service Centre please check the following chart. PROBLEM REMEDY The appliance is not working • Make sure the gas cock is open •...
Page 20
TECHNICAL FEATURES BURNER DISPOSITION AND HOB BURNER TECHNICAL DATA TABLE DIAMETER AIR REG. OPERATING BURNERS RATE INJECTOR HEAT INPUT SLEVE PRESSURE GAS PASS SABAF OPENING DENOMINATION mbar 1/100 mm “X” mm 1/100 mm G30 - Butano 28-30 1600 3800 Ultrarapid G31 - Propano 1600 3800...
INSTRUCTIONS FOR THE INSTALLER TECHNICAL INFORMATION INSTALLATION • The installation, adjustments, conversions and maintenance operations listed in this part must UNPACKING YOUR COOKER only be carried out by qualified personnel. The • Once the wrapping has been removed from the outer manufacturer cannot be held responsible for any surfaces and the various inner parts, thoroughly damage to persons or property resulting from an...
INSTRUCTIONS FOR THE INSTALLER VENTILATION The appliance should not be installed in a room of volume less than 20 m³. The quantity of air necessary is that required for a regular combustion of the gas and for the ventilation of the room.
Page 23
INSTRUCTIONS FOR THE INSTALLER SECURING THE COOKER TO WALL (fig.P) Note:- The installation of the chain provided is for safety reasons, it must be installed as indicated below. To prevent the cooker tipping forwards in the event of children standing on the oven door or where users put extreme weight on the door when in open position, two chains MUST BE fixed to the back of the oven which should at all times be secured to the threaded pins .
INSTRUCTIONS FOR THE INSTALLER accordance with the standard, with a maximum 2 metre GAS CONNECTION extension and seals in accordance with the standard. Before connecting the appliance check that the We recommend applying the special adapter to the data on the rating plate affixed to the cooker, flexible pipe, easily found on the market, to facilitate correspond to those of the gas mains.
INSTRUCTIONS FOR THE INSTALLER ADJUSTMENTS ELECTRICAL CONNECTION • Always disconnect the appliance from the electricity The electrical connection must be carried out in supply before making any adjustment. accordance with the current standards and laws • All seal must be replaced by the technician in force.
INSTRUCTIONS FOR THE INSTALLER OVEN THERMOSTAT (fig. 21) GRILL BURNER (fig. 23) Reduced rate adjustment should be carried out in the To adjust the primary air, light the burner and, following way: watching the flame, slacken screw (A) and adjust •...
INSTRUCTIONS FOR THE INSTALLER • Change seal each time a tap is replaced. This MAINTENANCE will ensure perfect retention between the tap or a Prior to any maintenance work or changing thermostat and part. parts, disconnect the appliance from the gas and •...
Page 28
INSTRUCTIONS FOR THE INSTALLER CHANGING THE FLEXIBLE GAS HOSE In order to guarantee that the gas hose is always in excellent condition we strongly recommend changing it on the date you will find printed on it. REPLACING THE ELECTRICAL COMPONENTS •...
Page 29
SPACE FOR DATA LABEL 461308290_000 10/2013...
Need help?
Do you have a question about the EKK945ABOX and is the answer not in the manual?
Questions and answers