Craftsman 11543 - C3 19.2 Volt Cordless Hammer Operator's Manual page 12

CHARGING A HOT BATTERY PACK
When using the tool continuously, the batteries in the
battery pack will become hot. You should let a hot bat-
tery pack cool down for approximately 30 minutes before
attempting to recharge. When the battery pack becomes
discharged and is hot, this will cause the green LED to
come on instead of the red LED. After 30 minutes, reinsert
the battery pack in the charger. If the green LED contin-
ues to remain on, return battery pack to the nearest Sears
Repair Center for checking or replacing.
NOTE: This situation only occurs when continuous use of
the tool causes the batteries to become hot. It does not
occur under normal circumstances. Refer to CHARGING
A COOL BATTERY PACK for normal recharging of batter-
ies. If the charger does not charge the battery pack under
normal circumstances, return both the battery pack and
charger to the nearest Sears Repair Center for electrical
check.
BATTERYPACK
SHOWNIN CHARGER
CHARGER
RED LED
GREEN
LED
YELLOW
LED
Fig. 3
TO iNSTALL BATTERY PACK
See Figure 4,
[] Lock switch trigger on the drill by placing the direction
of rotation selector in the center position.
[] Place battery pack in the drill. Align raised rib on
battery pack with groove inside drill.
CAUTION: When placing battery pack in the drill,
be sure raised rib on battery pack aligns with groove
inside drill and latches snap into place properly.
mproper assembly of battery pack can cause damage
to internal components.
[] Make sure the latches on each side of the battery pack
snap in place and battery pack is secured in drill before
beginning operation.
J
LATCHES TO
RELEASEBATTERYPACK
LATCHES
Fig. 4
TO REMOVE BATTERY PACK
See Figure 4,
[] Lock switch trigger on the drill by placing the direction
of rotation selector in the center position.
[] Locate the latches on the side of the battery pack and
depress to release the battery pack from the drill.
[] Remove battery pack from the drill.
12