tell EX8300 Series Installation Instruction

INSTALLATION INSTRUCTION
EX8300 SERIES EXIT DEVICE
Before Installation, Please Check:
1. If Door is Fitted And Properly Hung.
2. Size Of Exit Device, Function And Design
• 36"Doors, Can Be Cut To Fit Doors Down To 30" Wide.
• 48"Doors, Can Be Cut To Fit Doors Down To 36" Wide.
• Hand Of Device Against Application.
Chassis
Assembly
Horizontal
Chassis
1. Type of Installation
SINGLE DOOR
(OUTSIDE)
DOOR DOOR
2. Apply Hardware
2.1 Drill Holes
Mark door face and drill holes in accordance
with the diameters suggested.
See attached template.
(OUTSIDE)
DOOR
2-3/4"
1-1/16"
(INSIDE)
OUTSIDE FACE OF THE DOOR
2.2 Install Cylinder
LINER
CYLINDER
INSTALLATION
SCREW
(#10-24 x 1 ")
CYL RING
Tell Manufacturing | A Division of Spectrum Brands Inc.
DOUBLE DOOR DOUBLE DOOR WITH
WITH MULLION NO MULLION
(OUTSIDE) (OUTSIDE)
DOOR
FOLD HERE FROM JAMB
7/8"
3/16"
3/16"
2-1/4"
CENTER OF CYLINDER END OF BODY
INSIDE FACE OF THE DOOR
1. Insert the cylinder through Cyl Ring and
hole in the door.
2. Keep the tail piece horizontal.
3. Mount liner on inside of door and
4. Tailpiece projection over inside of Door is
suggested in the range 9/32" - 15/32. If
necessary, use a pliers to bend and cut to
desired length.
9/32" - 15/32
TAILPIECE PROJECTION
DIAGRAMS ARE NOT TO SCALE.
Surface Of Door Must Be
Flushed To Apply Exit Device
Mounting
Rail
Push Rail
2.3 Install Lever, Knob, or Pull Trim
LEVER TRIM
Head
Cover
KNOB TRIM
MOUNTING
BRACKET
PLUNGER
3. Apply Rail Assembly
1. Check the size of device, if cutting to length Is required.
2. Determine cut off length "x" by subtracting 1-3/4" From "y" .
Mark cut off point on mounting rail.
VERTICAL
CHASSIS
3. Depress arm into rail opening and slide rail onto chassis. Level rail and
fasten chassis and mounting plate.
3-1/2"
RAIL ASSEMBLY
4. Apply Covers and Strike
ATTACH COVER TO CHASSIS
WITH (4) #8 TRUSS HEAD
MACHINE SCREW
1
Rail Mounting
Bracket
Sliding Shim
Dogging Hex
Key
ATTACH OUTSIDE
PULL TRIM IF USED.
IF W/0 TRIM, ATTACH CHASSIS
WITH (4) #10 WOOD OR
MACHINE SCREW.
MOUNTING
SCREWS
AT 12:00
POSITION
CHASSIS MOUNTING SCREWS
FOR DOOR W/STILE
CUT OFF MUST LEAVE
1/2'" MIN OVERLAP
WITH RAIL
1-3/4" MIN
X
DON'T CUT CLOSER THAN
Y
1-3/4" FROM LOWER PIVOT
MOUNTING PLATE TO DOOR
ATTACH END CAP TO ATTACH STRIKE TO DOOR
MOUNTING PLATE WITH (2)
COVER SCREWS. SCREW AND LOCK WASHER
READ AND FOLLOW
INSTRUCTIONS
CAREFULLY.
Incorrect installation or
adjustment could cause
damage or injury.
End Cap
CUT OFF AND DEBURR
TIGHT AGAINST RAIL
ATTACH MOUNTING PLATE
TO DOOR WITH (3) ROUND
HEAD SCREWS.
STOP WITH (2), STRIKE
1-800-433-4047 | EX8300-2016-ENG