Litter-Robot 4 Cleaning Instructions

Litter-Robot 4 Cleaning Instructions
Cleaning the Globe
1. Press the Empty button to cycle the Globe clockwise, which will allow the litter to fall through the
Waste Port and into the Waste Drawer for easy disposal. Sweep any leftover litter toward the Waste Port.
Then, press either Cycle or Reset to return the Globe to the Home position. Ensure that all litter has been
removed from the Globe—wet litter turns into messy clay!
2. Turn the Litter-Robot OFF and unplug the unit.
3. Open the Bonnet: Press and hold the buttons on both sides of the Bonnet, then lift and rotate the
Bonnet to its open position.
4. Remove the Globe: Using the handle, lift the Globe o the Base.
5. Remove the Carbon Filter.
6. Clean the Globe with Litter-Robot cleaner spray or wipes, or with water and a mild soap. There are no
electronic components in the Globe that can be damaged by soap and water. If the Globe has become
extremely dirty, it can be soaked and cleaned with a water hose.
7. Let the Globe dry completely before reassembling it to the Base and closing the Bonnet (see page 27).
For a quick touch-up, you can use Litter-Robot cleaner wipes or a disposable towelette to wipe the inside
and upper half of the Globe (without removing the litter). You can also manually rotate the Globe to a
position where the litter is behind the screen, providing access to the Flexible Globe Liner surface for
spot cleaning. The Litter-Robot can then be used almost immediately, since drying is nearly
instantaneous.
Litter-Robot cleaner spray and wipes can be ordered at litter-robot.com
Cleaning the Waste Drawer
1. Pull the Waste Drawer out.
2. Clean the drawer with Litter-Robot cleaner spray or wipes or with soap and water.