Table of Contents
Advertisement
To return the seat to the passenger position, lift the
load floor panels and latch them into the seatback.
Then lift the rear seatback up and push rearward until it
latches. Return the head restraints
to their original positions
and lower the seat cushion until it latches into position.
After returning the seat to the passenger position, pull
forward on the seatback and up on the cushion to make
sure the seat is locked into place.
If the latch plate portion of the center safety belt was put
in the center armrest when the seat was folded, take the
latch plate portion out and place it on the seat. That way,
the center position safety belt will be available for the
center rear seat passenger to use.
Entry to the Rear Seat (Suburban Second Seat)
The right side of the rear 60/40 split folding bench seat
has an easy entry feature. That makes it easy to get in
and out of the third seat, if you have one.
To operate the seat, move the lever at the side of the
seat down.
Tilt the seatback toward the front of the vehicle by
pulling the top of the seatback forward.
When you do, the seat bottom will release. Just pull the
seat forward until it stops.
There is a foot-operated
release lever for rear seat
1-13
Advertisement
Table of Contents
