Slime SMART SPAIR PLUS Manual

OVERVIEW

ATTENTION! READ ALL INSTRUCTIONS CAREFULLY
Failure to follow warning instructions can result in fire, PERSONAL INJURY or property damage.

Slime® provides a quick emergency repair. Treated tires should be repaired by a qualified tire professional at the earliest opportunity to ensure safety and proper cleaning of tire pressure sensor, if so equipped. We recommend treated tire be repaired within 3 days or 100 miles after use of Slime Tire Sealant, whichever comes first. Advise tire professional of product use.

VEHICLE EXHAUST WITHOUT PROPER VENTILATION IS EXTREMELY DANGEROUS. ALWAYS ALLOW FOR PROPER VENTILATION.

Ensure that the vehicle is outside, or in an open, well-ventilated area and NOT INSIDE A CONFINED AREA, SUCH AS A GARAGE as bodily injury or asphyxiation resulting in death could occur. Always operate the inflator in a well-ventilated area free of combustible materials, gasoline, or solvent vapors. Always set parking/emergency brake and ensure vehicle is in Park (or neutral if equipped with manual transmission).

CONTENTS UNDER PRESSURE. HARMFUL OR FATAL IF SWALLOWED. Irritant to skin and eyes. May explode if heated.

PRECAUTIONARY MEASURES: Do not eat, drink, or smoke when using this product. Wear eye protection (safety goggles, eyeglasses, sunglasses, etc.) and protective gloves during use. Use in a well-ventilated area. Do not breathe mist, vapors, spray. Wash hands after use. DO NOT use if any portion of this product is dented or damaged. TEMPERATURES INSIDE CAR CAN EXCEED 120F. Store outside passenger area of car secured in spare tire well or trunk. DO NOT use on motorcycle or bicycle tires. Contains ethylene glycol, natural rubber latex.

FIRST AID: INHALATION: If inhaled, seek fresh air. SKIN CONTACT: If on skin, wash thoroughly with soap and water. Seek medical help for persistent irritation or rash. EYE CONTACT: Flush with plenty of water for 15 minutes, lifting eyelids occasionally. If irritation persists, call a physician. INGESTION: Do not induce vomiting. Call a physician or poison control center immediately. For HEALTH EMERGENCY, CALL: 1-800-255-3924.

HOT • DO NOT HOLD IN HAND WHILE OPERATING

NOTICE: ENGINE SHOULD BE RUNNING WHILE USING THIS INFLATOR

It is recommended that you operate your inflator with your vehicle's engine running to achieve the optimal inflator performance. Never start a vehicle with the inflator plugged into the DC 12 Volt power socket.

• Do not attempt to disassemble the inflator.
• No user serviceable parts inside. The only user serviceable part is the replaceable fuse.
• Keep inflator out of reach of children.
• Place inflator on a hard, clean surface.
• Ensure air hose chuck touches the core of the valve stem for proper inflation.
• DO NOT use inflator continuously for more than 10 minutes. Allow unit to cool approximately 25 minutes between uses. Do not leave inflator unattended.
• ALWAYS use a pressure gauge to check tire pressure. DO NOT over-inflate.
• Soft inflatables (i.e. rafts, balls, etc.) may not have recommended pressure markings.
• Be careful not to inflate items beyond their capacity.
• While operating, never block the inflator input or output.
• For use with 12 volt DC power outlets rated 15 amps or higher. Do not use with older 8 amp cigarette lighter receptacles.

TECH SPECS

* (0-35 PSI, Standard Tire: P195/65 R15)

NOTE: Engine should be running while using this inflator. See Warning Section for further details.

REPAIR TIRES

1. Start by rotating tire so that the valve stem is at the 6 o'clock position.
2. Shake can vigorously for 15 seconds.
3. Turn can upside down and screw plastic nozzle clockwise onto tire valve.
4. Allow 30 seconds for can to discharge fully. Unscrew nozzle when empty.
5. Inflate the tire to recommended pressure. See next page for inflation instructions.
6. Drive for 2 mi (3.2km) and stop to verify that the puncture has been sealed. Check tire pressure. Reinflate if necessary.

SEALANT REMOVAL INSTRUCTIONS

FOR THE TIRE REPAIR PROFESSIONAL
Slime Tire Sealant is non-flammable and water based so clean up is simple. The sealant should be rinsed or wiped out of the tire prior to making a permanent repair. Should any sealant fall on the shop floor, simply wipe it up with a rag and rinse off the area with water. If TPMS sensor is present, wipe sensor with damp rag prior to reinstallation. This sealant will not corrode or negatively affect the rim or tire.

NOTE: Engine should be running while using this inflator. See Warning Section for further details.

INFLATE TIRES

1. Attach quick connect air hose onto tire's valve stem and pull lever up to lock.
2. Plug power cord into 12 volt accessory power outlet.
3. Press ON/OFF switch to turn on inflator. Inflate tire to manufacturer's recommended air pressure.
   * When proper pressure is reached, press ON/OFF switch to turn off inflator. Unplug power cord and remove air hose connector.

*NOTE: Correct tire pressure can be found in vehicle owner's manual or on driver's side door jamb.

TROUBLESHOOTING

Inflator does not turn on:

1. Check the fuse. It may have blown: 12V fuse is located in the plug adapter. To replace, unscrew the tip, remove fuse, and inspect. If necessary, replace fuse with 15A, 250V (5mm×20mm).
   
2. Check vehicle's power outlet fuse; it should be a minimum of 15 amps.
3. Check receptacle and plug terminals for dirt (particularly tobacco). Use a non-conductive probe (not fingers or metal) to dislodge and remove debris.
4. Push the power plug firmly into the receptacle and twist it back and forth.

Inflator runs but does not inflate:

1. Be sure the air hose connector is secured tightly onto the valve stem.
2. Check tire for leaks. Check hose for breaks and leaks at fittings.

Inflator runs slowly:

1. The inflator may have overheated from excessive use. Shut it off and allow it to cool for 25 minutes.
2. The voltage may be too low. Check the condition of your vehicle's battery.

NOTE: If tire is totally deflated, it is possible that the tire could separate from the rim allowing air to leak out when trying to inflate. In the event this occurs, it may be necessary to jack up the tire prior to inflation.

Dispose of this product at an e-waste recycling collection point or facility. Do not place in the trash or standard recycling receptacle.

FOR WARRANTY INFORMATION GO TO: WWW.SLIME.COM/WARRANTY

QUESTIONS OR COMMENTS: Call (888)457-5463 or visit www.slime.com

ITW Global Tire Repair • 125 Venture Drive, Suite 210, San Luis Obispo, CA 93401 USA