Buyers SaltDogg 6196335 Installation & Operator's Manual

Installation & Operators Manual
6196335, 6198335
Liquid Spray System
Installation
The liquid spray system main body is mostly pre-assembled.
Follow these instructions to install the system on the truck.
1. Install the bag 3017862 or 3017861 into the pick-up bed.
2. Place the spray system into truck receiver and secure with
provided hitch pin and hairpin.
3. Remove lid from pump unit. Slide 14" hose WSE127
through back side off pump unit and connect to 90 degree
fitting. Use clamp WSE95 to secure hose properly to fitting.
Install quick connect coupler WSE118 to opposite end of hose.
Again, secure with clamp WSE95.
4. Assemble the bushing reducer WSE101 to the bladder bag,
along with a 90 degree fitting WSE112. Insert long 10' hose to
fitting and clamp WSE95 in place. Cut the hose accordingly
and finish assembly with a straight barb fitting along with
clamp WSE95. The sraight barb WSE119 will be used with the
quick connect fitting WSE118 on the supply hose coming from
the pump system.
5. Insert the remaining 14" hose on the manual valve located
in the middle of the spray unit base. Use clamp WSE95 to
secure in place. Place clamp WSE95 on opposite side of hose
and snug for the time being. Once the spray bar is connected,
connect the hose to center section of spray bar barb and
secure with clamp. This hose may need to be trimmed.
6. To install the spray bar WSE164, attach the two clamp
connectors WSE163 to the spray system bracket. The two
connectors will bolt to the system and will then clamp to the
spray bars.
Tighten the spray bars to center section by threading
TM
Phone (440) 974-8888 • Fax (440) 974-0165
clockwise on both sides until the o-ring seals are snug and
the nozzles are pointing towards the ground. Reflective tape is
provided to apply on the spray bar as desired.
Electrical connections
Route wire harness WSE154 from spray unit to engine
compartment of truck. Make sure the preassembled
connector is located near the spray system. The bare wires
will be routed to the engine compartment where the white
wire will be connected to the positive side of the battery
and the black wire will be connected to the negative side of
Do not connect the sprayer to the battery until all other
connections are made. Ensure the wire is fastened
securely in engine compartment and along entire frame.
Use zip-ties to secure properly.
battery.
Mount the toggle switch 6391001 in a convenient place
inside the truck cabin. Now route WSE142 wire harness to
the switch, again make sure to leave the pre-assembled
connector on the spray system side. Once the harness is in
place:
Connect the black wire to good ground. Connect the white
wire to the black wire on the toggle switch.
On the toggle switch: Connect the green wire to a good
ground. Connect the red wire to switch with ignition (fuse
box). See fig #1 for wiring diagram.
1
9049 Tyler Blvd. • Mentor, Ohio 44060
Toll-Free Fax 800-841-8003 • saltdogg.com
WARNING
—continued