Ip Telephone Start Up Sequence - Toshiba DKT3010-SD - Digital Phone User Manual

6. If the IPT is connected to a router or other gateway device, press
router address, then press
setting.
7. Press
telephone's primary number (PDN).
8. Press
the BIPU-M1A to which this IPT interfaces, then press
for CTX networked systems only.
9. Press
: manual setting, then press
then press
format
: auto setting by broadcast, then press
: auto setting by multicast (IPT doesn't support multicast setting in this first
release), then press
10. Press
11. Go off-hook and hang up. The IPT will search for the BIPU-M1A, initialize and
then set the IP address (from 20 sec. to 60 sec.). Time, Date and PDN displays on
LCD when the information is set.
Note See

"IP Telephone Start Up Sequence"

that you will see during this procedure.
IP Telephone Start Up Sequence
After the IP telephone network setting has been programmed, the following displays
occur after the IP telephone is hung-up:
Action
1. IPT
initializes.
Strata CTX DKT/IPT Telephone
. Enter a Station ID for the IPT and press
to enter the CTX Strata Net node number of the CTX node that contains
for BIPU IP address mode. Press one of the following:
. (e.g., if the BIPU IP address is "192.168.1.241," enter it in this
).
.
again to set all the above data.
LCD Indication
INITIALIZING
PLEASE WAIT...
06/03
IPT-to-IP Network Connection Instructions
. Only used if Step 3, above, is set for manual
. Press and enter the BIPU IP address,
.
below for an explanation of the LCDs
IPT1020-SD Settings
. Enter the
. This is usually your
. This FB setting is
Remarks
93