Pioneer AVIC-D1 Installation Manual page 13

Extension lead (for speed signal)
Note:
Cords for this product and those for other products
may be different colors even if they have the same
function. When connecting this product to another
product, refer to the supplied manuals of both prod-
ucts and connect cords that have the same function.
Violet/white (REVERSEGEAR SIGNAL INPUT)
This is connected so that the navigation system can
detect whether the vehicle is moving forwards or
backwards. Connect the violet/white lead to the
lead whose voltage changes when the shift lever is
put in reverse. Unless connected, the sensor may
not detect your vehicle traveling forward/backward
properly, and thus the position of your vehicle
detected by the sensor may be misaligned from the
actual position.
Note: When you use the ND-PG1 speed pulse
generator (sold separately), please make sure
to connect this lead.
When you use a rear view camera, please make
sure to connect this lead. Otherwise you cannot
switch to rear view camera picture.
See Page 15.
Be sure to use only the supplied extension lead. Use of another
lead could cause fire, smoke and/or damage this product.
Extension lead
5 m (16 ft. 5 in.)
(for reverse signal)
Check the position of your vehicle's
reversing lamp (the one that lights up
when the shift lever is in reverse [R])
and find the reversing lamp lead in the
trunk.
This product
Power cord
For information on other leads
See Page 9.
Connection method
Clamp the reversing lamp lead.
Clamp firmly with
needle-nosed pliers.
Fuse resistor
Reversing
lamp lead
12