Changing The Battery In The Stylus Pen - Hitachi StarBoard WT-1 User Manual

User guide
Hide thumbs Also See for StarBoard WT-1:
Table of Contents

Advertisement

WT-1
StarBoard

2.2.3 Changing the battery in the Stylus pen

The stylus pen contains a single AAA alkaline battery. If the pen begins to operate
erratically (e.g., if pen input is cut off), change the battery as described below. Note that
battery life is approximately 1680 hours under normal usage.
Be sure to orient the battery correctly.
Do not reverse the + and - terminals of the battery, and use only the specified type of battery.
Otherwise, it will overheat and fail.
When changing the battery, be careful not to close the pen's rear part too
forcefully.
If too much force is applied when closing the rear part of the stylus pen, the pen may be
damaged.
(1) Turn the stylus pen grip to separate the two halves.
(2) Remove the AAA alkaline battery contained in the grip, and insert a new cell with the
positive end facing the pen tip.
NOTICE
+
2-6
Usage Procedures
-
English

Advertisement

Table of Contents
loading

Table of Contents