Fun & Function SpaceKraft SP7169 Installation Instructions Manual

Interactive hallway wall panel

Advertisement

Quick Links

Interactive Hallway Wall Panel
SP7169
Installation Instructions
23126
October 2024

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SpaceKraft SP7169 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Fun & Function SpaceKraft SP7169

  • Page 1 Interactive Hallway Wall Panel SP7169 Installation Instructions 23126 October 2024...
  • Page 2: Table Of Contents

    Contents Warnings Description Includes Installation Cleaning and Maintenance Guarantee Technical, Contact Us...
  • Page 3: Warnings

    Warnings All our equipment is designed for users with special needs. We suggest supervision at all times when using this equipment. For indoor use only. Do not install in wet areas. The panel uses a power supply. Do not use any other power cord other than the one supplied. Before plugging in the power cord, ensure it is the cord supplied with your product.
  • Page 4 Step 1 Attach the 9 mirror plates to the back panel. Measure 1 inch down from the top edge and mark a line across the entire width of the panel. Measure in 1 inch from the side edge on both sides and mark a line down each side. The line will be the center line to place the screws.
  • Page 5 Two people are required for Step 2. Step 2 Place the panel in the position and location where it will be attached to the wall. Using a level, with the wall panel against the wall, ensure the mirror plate holes are level. Use a pencil to mark through the holes in the mirror plate onto the wall.
  • Page 6: Cleaning And Maintenance

    Cleaning • Before cleaning, unplug all equipment from the electrical outlet. • Wipe with a soft, lint free white cloth and mild detergent such as dishwashing liquid diluted with water. • Never use an abrasive cloth or any solvent such as paint thinner/mineral spirits, ammonia or chlorine based products.
  • Page 7: Fcc

    Information about products that generate electrical noise USA and Canada This device complies with FCC and industry Canada RF radiate exposure limits set forth for general population. It must not not be co-located or operating in conjunction with any other antennas or transmitters. This device complies with Part 15 of the FCC rules.
  • Page 8: Guarantee

    Guarantee CONDITIONS OF GUARANTEE This guarantee is in addition to and does not in any way affect any statutory or other rights of consumer purchasers .If within the applicable guarantee period (as shown in 8 below) the appliance proves to be defective by reason of faulty design, workmanship or materials, we undertake subject to the following conditions to have the defective appliance (or any part or parts thereof) repaired or at our discretion replaced free of charge.
  • Page 9: Technical, Contact Us

    Technical The tactile panel uses mains power and is transformed to a safe low voltage. Complies to: BS EN 60355-1 Generic EMC standards - Emission standard for residential, commercial and light-industrial environments The power supply is fitted with a 3 Amp fuse. Disconnect the power before attempting to replace.

Table of Contents