Table of Contents
Advertisement
90
Heating and air conditioning system
Using the system
Setting temperature
A
⇒ fig. 106
– Turn the control dial
A
temperature.
A
– Turn the control dial
to the left in order to increase the tempera-
A
ture.
Controlling blower
A
– Turn the blower switch
B
switch the blower on.
A
– Turn the blower switch
B
off.
A
causes the recirculating air system ⇒ page 91
– Pressing switch
D
to be switched on.
Control for air distribution
– You can adjust the direction of the inlet air flow ⇒ page 92 using air
A
distribution regulator
.
C
Fig. 106 The air condi-
tioning system: Control
elements
B1Z-0042H
B1Z-0042H
to the right in order to increase the
into one of the positions, 1 to 4, in order to
into position 0 in order to switch the blower
switching cooling on and off
A
– Press the switch
. The symbol
AC
E
– When you again press the switch
off. The symbol
in the button is no longer illuminated.
Note
•
The whole heat output will be needed to unfrost the windscreen and side
windows. No warm air will be fed to the footwell. This can lead to restriction of the
heating comfort.
•
If the cooling system has not been switched on for a lengthy period, odours may
be produced at the evaporator because of deposits. Switch the air conditioning
system on at least once a month for approximately 5 minutes at the highest blower
stage - also during the cold season of the year - in order to remove such odours.
Also open a window for a short time.
•
Please refer to the information regarding recirculated air mode ⇒ page 91.
Setting air conditioning system
Recommended settings of air conditioning controls:
Defrosting the windscreen and side windows
•
A
⇒ fig. 106
Turn control dial
to the right up to the stop,
A
•
A
Blower switch
in position 4,
B
•
A
Turn the air distribution control
•
Close the air outlet vents 3,
•
⇒ page 92, fig. 107
Open air outlet vents 4
Keeping winscreen demisted
We recommend that you use the following setting in cases where the windows are
misted up more than usual (e.g. when it is raining):
•
A
Blower switch
in position 2,
B
•
A
Turn the air distribution control
in the switch comes on.
, the cooling system is switched
AC
into the position
,
C
and point towards the side window.
into the position between
and
C
,
Advertisement
Table of Contents
