Table of Contents
Advertisement
WARNING (continued)
•
The backrests must not be angled too far back when driving otherwise
this will affect proper operation of the seat belts and of the airbag system -
risk of injury!
Note
If the movement of the seat is inadvertently interrupted during an adjustment, once
again press the switch in the appropriate direction and continue with the adjust-
ment of the seat to the end.
Memory for the seat
Memory buttons
Memory for the seat offers the possibility to store the individual seat and external
mirror position. An individual position can be allocated to each of the three
A
⇒ fig.
memory buttons
D
A
memory button
the seat and external mirror will automatically move into the
D
position allocated to this button.
ON/OFF switch
A
If you press switch
(increased switch position), the memory buttons
E
longer operate. You can now adjust the seat electrically without using the memory
Using the system
Safety
Fig. 55 Driver seat:
Memory buttons and
ON/OFF switch
55, that is three in total. On pressing the appropriate
Driving Tips
A
buttons
. After pressing switch
D
memory buttons. If you had already started an operation to retrieve the settings,
this operation is not continued.
If the car is used only by one driver, it is not necessary to store particular settings in
this case, we recommend that you press the button
Emergency Off
If you operate any button or the switch ON/OFF switch of the driver seat, you can
interrupt the setting operation at any time in an emergency.
Storing and retrieving settings
Storing seat and exterior mirror settings for driving forward
– Switch on the ignition.
– Adjust the seat ⇒ page 60.
– Adjust both exterior mirrors ⇒ page 57.
– Press the desired memory button
about 3 seconds until an audible signal confirms that the setting has
been stored.
Storing exterior mirror setting for reversing
– Switch on the ignition.
– Turn the exterior mirror control to position
– Engage reverse gear.
– Move the right exterior mirror into the desired position ⇒ page 57.
– Press the desired memory button
about 3 seconds until an audible signal confirms that the setting has
been stored.
A
no
D
General Maintenance
Seats and Stowage
A
once again, the seat can be reset with the
E
A
(increased switch position).
E
A
and hold the button pressed for
D
⇒ page 57, fig.
A
and hold the button pressed for
D
Breakdown assistance
Technical Data
61
52.
Advertisement
Table of Contents
