custom alarm DMP 7060 Quick Reference Manual

DMP 7060
Arm
1. Press "CMD" until "ARM" and "DISARM" are shown.
2. Press the button under "ARM".
3. Enter your 4-digit user code followed by "CMD".
4. To Arm all areas, press the button under "Yes" at the "All?" prompt. To
selectively Arm only certain areas, press the button under "No" at the
"All?" prompt, then select Yes or No on the desired areas to be Armed.
5. The entry delay will begin, exit the building. If you need to cancel
arming, press command until "ARM" and "DISARM" are displayed,
then follow the normal process for Disarming.
Disarm
*If entering an Armed building/area and the entry delay is in progress, skip to step 3.
1. Press the "CMD" button until "ARM" and "DISARM" are displayed.
2. Press the button under "DISARM" on the keypad.
3. Enter your 4-digit user code then "CMD".
4. To Disarm all areas, press the button under "Yes" at the "All?" prompt.
To selectively disarm areas, press the button under "No" at the "All?"
prompt, then select Yes or No on the desired areas to be disarmed.
5. If you are Disarming after an alarm has been triggered, you will be
asked "False Alarm Yes/No", choose the appropriate option, system
will then be fully disarmed.
Quick Reference Guide