Page 1
H YDR O P U RY W F HU MI D I F I E R WI TH P UR IF ICAT IO N OPERATING INSTRUCTIONS Read the instructions carefully before operating the appliance or carrying out maintenance work. Observe all the safety instructions;...
Page 2
GENERAL OPERATING AND SAFETY INSTRUCTIONS • The appliance is a very effective humidifier: use this humidifier only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or malfunction. • Make sure that the type of electrical power supply complies with the electrical requirements of the product (220-240V~50/60Hz).
Page 3
• Do not immerse the cord, plug or any other part of the appliance in water or other liquids. • Do not touch the plug with wet hands. • Do not inhale the steam emitted from the nozzle. • Do not use acidic or basic solvents to clean the inside of this appliance: the residues could affect the proper functioning of the appliance.
Page 4
with the water that forms in the lower part, do not scratch the atomizer or the ceramic disc with hard objects. • The internal ultrasonic nebulizer is highly sensitive. Do not touch it with your fingers or rub it with metal accessories to avoid reductions in the emission of steam.
• Do not use hot water to avoid damage to the parts that generate steam. The manufacturer cannot be held responsible if the indicated safety and accident prevention regulations are not respected. DESCRIPTION OF THE APPLIANCE Inside base Bottom of water tank 1.
Page 6
OPERATIONS BEFORE START UP Place the humidifier on a flat, stable surface, keeping it at least 15 cm away from the wall and other objects. The humidifier should be placed on a water-resistant surface, avoiding carpets, tablecloths or any absorbent surface. Make sure that the cable is not connected to the power supply when water is added to the humidifier.
OPERATION OF THE UNIT CONTROL PANEL Display 1. ON/OFF button 2. NIGHT LIGHT/SLEEP button 3. HUMIDITY button 4. SPEED button 5. TIMER button 6. Wifi button 1. ON/OFF BUTTON Press ON/OFF button to turn the unit on or off. Press once to activate the steam emission, the display shows the humidity in the room, the unit starts to operate in Continuous mode (CO appears on the display) and medium steam emission speed.
Page 8
UV-C LAMP The UV-C lamp is always active when the unit is in operation. To avoid the risk of exposure to ultraviolet rays the lamp is enclosed in a safety interlock. The LED remains lit on the control panel during operation. The UV-C lamp LED turns off if the water tank is removed while the unit is in operation.
CARE AND MAINTENANCE WARNING! Before cleaning and maintenance, remove the plug from the electrical outlet. IMPORTANT: DO NOT IMMERSE THE HUMIDIFIER IN WATER. 1. Cleaning the casing Turn off the appliance and remove the plug before cleaning or moving the appliance. Use a soft cloth to remove dust from the product.
Page 10
When a fault occurs, do not attempt to repair the humidifier, check whether it can be resolved by consulting the table below. If the problem persists, contact an Argoclima Service centre. Problem Possible cause Solution The plug is not inserted correctly Remove the plug from the power outlet and try to turn the unit on again Power failure...
Page 11
www.argoclima.com Argoclima assumes no responsibility for any errors or inaccuracies in the content of this manual and reserves the right to make to this, at any time and without notice, any changes deemed appropriate for any technical or commercial need. V 01/25...
Need help?
Do you have a question about the HYDRO PURY WF and is the answer not in the manual?
Questions and answers