Tekvox TekTouchPad Wall Installation Manual

TekTouchPad - Wall
78034 Installation Guide
Included in this Product Package:
Back Mounting
TekTouchPad
Step 1: Select Location for TekTouchPad
Step 2: Cut Hole for Single-Gang Bracket
In desired TekTouchPad location, use a pencil to lightly sketch a 2-1/8" wide x 3-5/8" tall
rectangle for locating the single-gang bracket. Confirm that the wall in the selected
location is free of electrical wiring, water lines, wall studs, or any other obstructions before
making any cuts.
Using a drywall saw, carefully cut out the sketched rectangle, discarding the interior
portion. Clean away all dust and debris from the cutting process.
Step 3: Mount Single-Gang Bracket
Ensuring that "UL" logo is in the top left corner of the single gang bracket, firmly press
the bracket into the rectangular cutout in the wall. Make sure that the bracket seats fully
Top-Left
into the wall, with all sides flush against the outer surface.
Corner
With the bracket flush against the outside of the wall, gently tighten the two (2) silver
screws built into the bracket. These screws rotate and secure the mounting flanges
against the opposite side of the wall, ensuring the TCX7 will be secure. Tighten screws
until snug. Do not overtighten, as this can cause the bracket to warp. Once both screws
are tightened, check that bracket is secure and stable.
Single-Gang
Plate
Bracket
TekTouchPad mounting location should be conveniently and easily
accessible. If possible, mount TekTouchPad centered between two
wall studs to minimize chances of interference. Do not mount
TekTouchPad where it may interfere with electrical wiring, water
lines, or any other existing infrastructure. In order to conform to ADA
standards, do not mount TekTouchPad higher than 48" off of the
ground. TekTouchPad, once mounted, occupies a space 2-3/4" wide
& 4-1/2" tall.
www.tekvox.com
25' Serial Cable
6-32 Machine
Screws (2)