HP LTO-4 Technical Reference Manual page 18

Peripheral Devices
Tape Drives
will then scan the system for any tape drives connected.
sam
For example, when an HP LTO Ultrium 4 drive is found, it will be displayed as something like:
Hardware Path
===========================================================
8/0/2/0.3.0
Highlight the drive and select the following from the tool bar:
3.
Actions
Create Device Files
Create Default Device Files
This will create default device files for the drive. To view the device files that have been created,
select:
Actions
Create Device Files
Show Device Files
4. When you have exited
%/sbin/ioscan –fnC tape
All default device files displayed have compression enabled.
NOTE: HP recommends the 'Berkeley' device files for most applications:
cXtYdZBESTnb
cXtYdZBESTb
where:
= card number
X
= target number (drive SCSI ID)
Y
= LUN number
Z
For HP-UX 11i v3 (HP-UX 11.31)
Start up the SMH web-based interface:
1.
%
smh –w
This will attempt to launch a web browser. Mozilla browser
installed.
2. From the SMH Tools page (see
the Peripheral Devices section.
1. If Mozilla is being invoked for the first time you may be asked to agree to license terms for the software.
16 HP (HP-UX) servers and workstations
Driver
stape
, run to see the tape drive:
sam ioscan
= Berkeley, no rewind, best available density
= Berkeley, with rewind, best available density
Figure 3 on page 14), select Manage Peripheral Devices from
Description
HP Ultrium 4-SCSI
1
is the default when HP-UX 11i v3 is