HP LTO-4 Technical Reference Manual page 16

3. Highlight the stape driver. If the driver has not been added to the kernel, both Current State
and Planned State will read "unused".
Type "m" to modify the stape driver and "s" to set it to "static". The Planned State will now read
4.
"static".
5. The stape driver is now added to the kernel.
If you are going to attach an autoloader, use a similar procedure to change
6.
Reboot the system.
7.
For HP-UX 11i v3 (11.31)
1. Start up the SMH web-based interface.
% smh –w
This will attempt to launch a web browser. Mozilla browser
installed.
2. From the SMH Tools page (see
Figure 3 SMH web-based interface (HP-UX11i v3)
In the Search box on the Kernel Configuration page, type
3.
The search results list will include both
not installed both Current State and Next Boot State will be shown as "unused". A state of
"static" indicates that the module is installed.
1. If Mozilla is being invoked for the first time you may be asked to agree to license terms for the software.
14 HP (HP-UX) servers and workstations
Figure 3), select Modules from the Kernel Configuration section.
and
estape stape
schgr
1
is the default when HP-UX 11i v3 is
and execute the search.
stape
modules. If either of these modules is
to "static".