Last N Error Events List - Sony AIT-SDX450 Product Specifications Manual

6.Command Specification
The following parameter codes are supported for each Error Counters Page:
Parameter
Code
0003h Total Errors Corrected (Soft Errors)
0004h Total Times Correction
0005h Total Groups Processed (Algorithm
Processed)
0006h Total Errors Uncorrected (Hard Errors)

6.6.5. Last N Error Events List

This page is used to report information on soft and hard errors encountered by the device during normal operation.
Each parameter corresponds to an encountered error and is a report of what type of error occurred and when it
occurred. The format of the page is given below:
Bit 7
Byte
0 Reserved
1
2 (MSB)
3
4 (MSB)
5
6 DU(0)
7
8
17
The Parameter Codes supported are 1 through 30 where 30 is the maximum number of entries in the log page.
If there are no entries, the command will return the Page Header with the Page Length field set to ZERO.
Each error event record contains diagnostic information for a single error encountered by the device. The parameter
codes associated with the error-event records indicate the order in which the errors occurred. A higher parameter
code indicates that the error event occurred later in time.
Each parameter entry is 10 bytes long and has the following format:
6-18
Table 6-14: Page Code
Page Code
02h Write error Counter Page
03h Read error Counter Page
Table 6-15: Error Counter parameter codes
Description
Table 6-16: Last N Error Events Page
6 5
DS(1) TSD(0)
Parameter Length (0Ah)
Description
Parameter
Length Cumulative
(Bytes)
2
4
4
2
4 3
Page Code (07h)
Reserved
Page Length (n*14)
Parameter Code
ETC(0) TMC(00)
Parameter Value
SONY AIT-1 Turbo drive SDX-450V series Ver.1.0
LOG SENSE
Default Default
Threshold
0 FFFFh
0 FFFFFFFFh
0 FFFFFFFFh
0 FFFFh
2 1
(LSB)
(LSB)
LP(1)
Reserved
0