Vaporfi vSix User Manual

SUB-OHM TANK
WHAT'S INCLUDED
» (1) vSix Tank (6ml)
» (1) OCC Sub Ohm 0.5Ω Single Coil/ Range: 15-35 W
» (1) OCC Sub Ohm 0.25Ω / Range: 10-50 W
» (1) OCC Ni200 0.25Ω TC Coil / Range: 10-60w, 0-450F
» (1) User Manual
REFILLING E-LIQUID
1.
Close e-liquid flow control by twisting the top of the vSix
tank. The inner barrel will block wicking holes to prevent
leaking.
2.
Open top-fill cap by twisting uppermost tank border
counter-clockwise.
3.
Point and pour the e-liquid into one side port of the tank
USER MANUAL
allowing air pressure of tank to evacuate via the vacant side
ENGLISH
port.
4. Screw the top-fill lid back onto the tank by turning the lid
clockwise until you feel resistance (make sure not to over
tighten).
5.
Let the tank sit for 1 minute to allow the wick to saturate.
CHANGING THE ATOMIZER HEAD
Atomizers generally last 1-3 weeks depending on individual
usage. When you notice that the flavor and/or vapor have
diminished, and/or you experience a burnt taste, it may be
time to change your atomizer.
1. Remove the tank from the battery and turn the tank upside
down.
2.
Unscrew the base of the tank by turning it
counterclockwise.
3.
Unscrew the atomizer.
4.
Screw replacement atomizer onto the base.
AIR FLOW CONTROL
The Air Flow Control at the base of the tank can be adjusted by
turning the control ring in either direction. Adjust the Air Flow
to your desire.
JUICE FLOW CONTROL
The Juice Flow control allows the user to control the flow of
e-liquid to the atomizer and can be adjusted by turning the
top base of the tank in either direction. Please make sure the
juice flow control is not blocking the liquid wicking holes.
Note: We suggest leaving wicking ports completely open
when using higher VG e-liquids.
WARNING: This is an advanced item. Please use proper
precautions and handling. Ni200 is designed for use only with
devices equipped with circuit boards capable of controlling coil
temperature.