Installing The Product Locally - F-SECURE POLICY MANAGER PROXY 2.0 Administrator's Manual

10 | F-Secure Policy Manager Proxy | Installation

Installing the product locally

Here you will find steps for installing F-Secure Policy Manager Proxy locally.
To install the product:
1. Run the setup.exe file.
2. Click the
3. Read through the license agreement and click the
4. Select where to install Policy Manager Proxy using the
Note: If a previous installation of an F-Secure product is detected on the computer, this dialog is not
displayed and the previous installation directory is used.
5. If a previous installation of the product is detected, you will be asked if you want to use the same settings
as in the previously installed product:
• If you select Yes, the dialogs in the following three steps will be skipped.
• If you select No, you can continue through the following steps and select new settings.
6. Select
7. Copy the admin.pub public key file from Policy Manager Server to the local system by clicking
and selecting the file, then click Next.
8. Enter the IP address of the Policy Manager Server installation you want Policy Manager Proxy to
communicate with, then click Next.
9. Click Start
When the progress bar is full, click Next. Policy Manager Proxy is now running.
10. Click Finish
In a centrally managed network, you should configure F-Secure products to use Policy Manager Proxy by
distributing a new policy with this configuration. For more information about policies and remote configuration,
see the Policy Manager Administrator's guide, which is available on the F-Secure web site at
http://www.f-secure.com.
Next button on the first page of the installation wizard.
Central management with F-Secure Policy
to begin the installation process.
to close the installation wizard.
I accept this agreement
Browse button, then click Next.
Manager, then click Next.
option, then click Next.
Browse