Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for GMC PL-20E
Summary of Contents for GMC PL-20E
- Page 4 This manual provides critical safety instructions on the proper setup, operation, maintenance, and service of this machine/tool. Save this document, refer to it often, and use it to instruct other operators. Failure to read, understand and follow the instructions in this manual may result in fire or serious personal injury—including amputation, electrocution, or death.
-
Page 5: Section 1: Safety
SECTION 1: SAFETY For Your Own Safety, Read Instruction Manual Before Operating This Machine The purpose of safety symbols is to attract your attention to possible hazardous conditions. This manual uses a series of symbols and signal words intended to convey the level of impor- tance of the safety messages. - Page 6 WEARING PROPER APPAREL. Do not wear FORCING MACHINERY. Do not force machine. clothing, apparel or jewelry that can become It will do the job safer and better at the rate for entangled in moving parts. Always tie back or which it was designed. cover long hair.
-
Page 7: Additional Safety For Milling Machines
Additional Safety for Milling Machines UNDERSTANDING CONTROLS: The mill is a STOPPING SPINDLE: To reduce the risk of complex machine that presents severe cutting or hand injuries or entanglement hazards, DO NOT amputation hazards if used incorrectly. Make sure attempt to stop the spindle with your hand or a you understand the use and operation of all con- tool. -
Page 8: Section 2: Power Supply
SECTION 2: POWER SUPPLY Availability Circuit Requirements for 220V Nominal Voltage ......220V/240V Cycle ............60 Hz Phase ............ 1-Phase Power Supply Circuit ......20 Amps Plug/Receptacle ......NEMA 6-20 Electrocution, fire, equipment damage may occur if machine is not correctly grounded and connected to the power supply. -
Page 9: Grounding Instructions
Grounding Instructions Serious injury could occur if you connect the machine to power before completing the setup process. DO NOT connect to power until instructed later in this manual. GROUNDED 6-20 RECEPTACLE Current Carrying Prongs 6-20 PLUG Extension Cords Grounding Prong Figure 5. -
Page 10: Section 3: Set Up
SECTION 3: SET UP Unpacking Needed for Setup Your machine was carefully packaged for safe The following are needed to complete the setup transportation. Remove the packaging materials process, but are not included with your machine. from around your machine and inspect it. If you discover any damage, please call us immediately For Lifting (Page 19) at 909-947-7787 for advice.
Need help?
Do you have a question about the PL-20E and is the answer not in the manual?
Questions and answers