Advertisement
Advertisement
Table of Contents
Related Manuals for TMC SEM-Base VI
Summary of Contents for TMC SEM-Base VI
- Page 1 SEM-Base VI tmc.service@ametek.com...
- Page 2 SEM-Base VI Quick Reference Guide tmc.service@ametek.com...
-
Page 3: Warranty Information
Let Us Know What You Think Thank you for purchasing SEM-Base VI. Please fill out this short survey. TMC continually strives to improve its service and solutions. By giving us your feedback, you’ll be providing valuable information techmfg.com/feedback and insight that will enable us to better serve you. - Page 4 (not case sensitive): techmfg.com/SemBaseGuide A password protected zip file will be downloaded. Inside it is the guide in PDF format. In order to read or copy the guide you will need to enter the following password when prompted: tmcinstopsembase19 tmc.service@ametek.com...
-
Page 5: Controller Interface
If other messages appear contact TMC Status LED LCD Navigation Buttons Ethernet Port Serial Interface for connecting to TMC service use and firmware upgrade user PC GUI USB type B connector Bi-Directional BNC For monitoring with oscilloscope or drive signal input tmc.service@ametek.com... -
Page 6: Status Led
Flashing Solid On • Recovered from an error during Normal mode of operation operation - Contact TMC • Unsaved parameter setting reminder Alternates between the two colors during initial self-test or in diagnostic mode. Flashing Solid On - Contact TMC Flashes for 30 sec. -
Page 7: Lcd Menu Navigation
Enable/disable alarms Moves down menu • Run diagnostics tree or decreases the value of a parameter • Gain adjustments • Enter shaker mode Download full Operation Guide for full menu tree Contact TMC Service before using Additional hardware needed tmc.service@ametek.com... - Page 8 PC/Mac directly to the DC 2020 controller. Connecting multiple SEM-Base systems to a network and managing them remotely via Ethernet is possible. Contact TMC for setup instructions. Open a web browser* and type the IP address displayed above in the address bar.
-
Page 9: System Control Functions
System Control Functions *Contact TMC before adjusting gains tmc.service@ametek.com... - Page 10 Alarm & Test Functions tmc.service@ametek.com...
-
Page 11: Troubleshooting
Excessive floor noise detected during “open loop” test • Improper installation (floor does not meet flatness and/or stiffness requirement) • System is simply not functioning correctly. Please contact TMC customer service . • Report all “FAIL” messages to tmc.service@ametek.com Controller Fails to Communicate LED status is not changing to GREEN. - Page 12 Thank You For further assistance or field service contact TMC using the contact methods listed below: +1 978-532-6330 +1 800-542-9725 (Toll Free) • tmc.service@ametek.com techmfg.com VIBRATION CONTROL 200813 tmc.service@ametek.com...
Need help?
Do you have a question about the SEM-Base VI and is the answer not in the manual?
Questions and answers