Bluetooth; Remote Control - Yamaha YHT-893 Owner's Manual

Bluetooth™

Display Cause
Searching... The Yamaha Bluetooth wireless
audio receiver and the Bluetooth
component are in the process of
pairing.
The Yamaha Bluetooth wireless
audio receiver and the Bluetooth
component are in the process of
establishing a connection.
Completed The pairing is completed.
Canceled The pairing is canceled.
BT connected The connection between the
Yamaha Bluetooth wireless audio
receiver and the Bluetooth
component is established.
Disconnected The Bluetooth component is
disconnected from the Yamaha
Bluetooth wireless audio receiver.
Not found The Bluetooth component is not
found.
See
Remedy
page
—
—
—
—
—
—
During pairing: —
– pairing must be performed on the
Bluetooth component and this unit
simultaneously. Check if the Bluetooth
component is in pairing mode.
During connecting:
– check if the Bluetooth component is
turned on.
– check if the Bluetooth component is
within 10 m (32 feet) of the Yamaha
Bluetooth wireless audio receiver.

Remote control

Problem Cause
The remote control Wrong distance or angle.
does not work or
function properly.
Direct sunlight or lighting (from
an inverter type of fluorescent
lamp, strobe light, etc.) is striking
the remote control sensor of this
unit.
The batteries are weak.
The remote control ID of the
remote control and this unit do not
match.
External components The remote control code is not
cannot be controlled
correctly set.
using the remote
control.
Even if the remote control code is
correctly set, there are some
models that do not respond to the
remote control.
APPENDIX
Troubleshooting
See
Remedy
page
The remote control will function within a —
maximum range of 6 m / 20 ft, and no more
than 30 degrees off-axis from the front
panel.
Adjust the lighting angle, or reposition this —
unit.
Replace all batteries. 4
Match the remote control ID of this unit and 66
the remote control.
Set the remote control code correctly using —
"Remote control code search" on the CD-
ROM.
Try setting another code for the same —
manufacturer using "Remote control code
search" on the CD-ROM.
If this unit does not work when you press —
Cursor B / C / D / E, do the following.
When the key does not work during DVD
disc menu operation: press the Input
selector again.
When the key does not work during Option
menu/Setup menu operation: press the key
corresponding to the current menu operation
again.
—
76
En