Before Using Remote Control (Inserting Battery) Remove the back cover. Insert 2 LR03 AAA 1.5 v batteries into the remote control. Reinstall the back cover. • After new batteries are inserted into the remote control, the display screen will lights up for 3 seconds.
Page 4
Before Using Remote Control Display Indicate operating status, temperature or timer setting Power Button Mode Button Turn ON / OFF the air conditioner Select operation mode -00- Page 06 -00- Page 06 Turbo Button Temporary boosting the air conditioner Increase / Decrease Button performance Adjust temperature / timer setting -00-...
Page 5
Before Using Remote Control LED Indicator Function LED Indicator Function Signal Indicator Indicate Temperature Value Auto Mode Fan Speed Cool Mode Mute Mode Dehumidify Mode Turbo Mode Fan Mode Child Lock Heat Mode Sleep Mode Low Battery Health Mode Gentle Wind Mode Anti-Mildew I FEEL Mode Timer...
Basic Operation Power ON Press • The air conditioner will start operating. Power OFF Press • The air conditioner will stop operating. Select Operation Mode Press to select operation mode. Auto Cool Dehumidify Heat • It may takes a few minutes for the air conditioner to switch between modes. •...
Page 7
Basic Operation Adjust Temperature Press to adjust temperature setting . • Temperature setting will adjust by 1°F / 1°C increment for each time the button is pressed. • Press and hold the buttons to adjust temperature continuously. • Temperature can only be set between 61°F - 88°F / 16°C - 31°C. Set Fan Speed Press to select your desired fan speed.
Page 8
Basic Operation Adjust Air Flow Press to oscillate horizontal flaps. The flaps will stop at the position it was in Press one more time. when you pressed the button. Press to oscillate vertical vanes . The vanes will stop at the position it was in Press one more time.
Advance Function Turbo Mode Using turbo mode can boost the air conditioner performance in a short amount of time. Press • The air conditioner will operate in boosted fan speed. • Turbo mode is not available when the air conditioner is operating in dehumidification mode. To stop turbo mode, press again or press Mute Mode...
Page 10
Advance Function ECO Mode The air conditioner will operate with maximum energy efficiency. Press • ECO mode is only available when the air conditioner is operating in cool or heat mode. • The set temperature for cool mode and heat mode will be limited. Press again or set the temperature beyond the ECO mode limit to cancel ECO mode.
Page 11
Advance Function Timer Function (Shutdown Timer) Set a timer to automatically turn OFF the air conditioner. Press when the air conditioner is ON. Press to set the desired turn off time. Press to confirm the timer setting. Timer Function (Start-up Timer) Set a timer to automatically turn ON the air conditioner.
Page 12
Advance Function I FEEL Mode Vicinity sensor function turns your remote control into a portable thermostat that automatically controls the unit to adjust the temperature of the room you are in. Press to activate vicinity sensor function. Air conditioner would operate to match the detected temperature to the set temperature.
Page 13
Advance Function Self Cleaning Self cleaning function allows the air conditioner to clean the interior parts and helps carry away the accumulated dirt, bacteria, etc. from the indoor evaporator. Press when the air conditioner is OFF. • will display on the indoor unit display. •...
Page 14
Advance Function Forced Defrost To maximize heat efficiency, you can force the outdoor unit to perform a defrost cycle before using heat mode. In heat mode, press 10 times within 8 seconds. • code will display on the indoor unit, and the AC will enter defrost cycle. Once the defrost cycle ends, the AC will automatically resume heat mode operation.
Compliance Information Radio Frequency Interference FCC Caution This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the 01 and is the answer not in the manual?
Questions and answers