Before Using Remote Control (Inserting Battery) Remove the back cover. Insert 2 LR03 AAA 1.5 v batteries into the remote control. Reinstall the back cover. • Do not use rechargeable batteries. • Replace the old batteries with new ones of the same type. •...
Page 4
Before Using Remote Control Display Indicate operating status, temperature or Power Button timer setting Turn ON / OFF the air conditioner Page 05 -00- Increase / Decrease Button Turbo Button Adjust temperature / timer setting Temporary boosting the air conditioner performance -00- Page 08...
Basic Operation Power ON Press • The air conditioner will start operating. Power OFF Press • The air conditioner will stop operating. HEALTH Select Operation Mode Press to select operation mode. • It may takes a few minutes for the air conditioner to switch between modes. •...
Page 6
Basic Operation Adjust Temperature Press to adjust temperature setting . • Temperature setting will adjust by 1°F / 1°C increment for each time the button is pressed. • Press and hold the buttons to adjust temperature continuously. • Temperature can only be set between 60°F - 90°F / 16°C - 32°C. Set Fan Speed Press to select your desired fan speed.
Page 7
Basic Operation Adjust Air Flow Press to oscillate horizontal flaps. The flaps will stop at the position it was in Press one more time. when you pressed the button. HEALTH Press to oscillate vertical vanes . The vanes will stop at the position it was in Press one more time.
Advance Function Turbo Mode Using turbo mode can boost the air conditioner performance in a short amount of time. Press • The air conditioner will operate in boosted fan speed. To stop turbo mode, press again. HEALTH Eco Mode The air conditioner will operate with maximum energy efficiency. Press •...
Page 9
Advance Function Timer Function (Shutdown Timer) Set a timer to automatically turn OFF the air conditioner. Press when the air conditioner is ON. Press to set the desired turn off time. Press to confirm the timer setting. To cancel shutdown timer, press again.
Page 10
Advance Function Sleep Mode In sleep mode, the air conditioner will operate a pre-set program which is suitable during sleep. Press • Sleep mode will operate for 10 hours and then switch back to previously set mode. • Sleep mode is not available when the air conditioner is operating in auto, dry or fan mode. Press again to stop sleep mode.
Page 11
Advance Function I FEEL Mode Vicinity sensor function turns your remote control into a portable thermostat that automatically controls the unit to adjust the temperature of the room you are in. Press to activate vicinity sensor function. Air conditioner would operate to match the detected temperature to the set temperature.
Page 12
Advance Function Anti-Fungus Function Anti-Fungus function allows the air conditioner to dry the interior parts after you turning off the air conditioner to prevent fungus or mold growth. Press the air conditioner is OFF. • The indoor unit beeps 5 times and the remote control display flashes 5 times indicating the Anti-Fungus function is enabled.
Page 13
Advance Function °C / °F Press to switch between degree Celcius and degree Fahrenheit. HEALTH v.20250505U...
Compliance Information Radio Frequency Interference FCC Caution This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the 02 and is the answer not in the manual?
Questions and answers