This motherboard uses the Micro ATX form factor.
Unplug the power cord before installing the motherboard. Failure to do
so may cause you physical injury and damage to motherboard
components.
1.6.1 Placement direction
When installing the motherboard, make sure that you place it into the chassis in
the correct orientation. The edge with the external ports goes to the rear part of the
chassis as indicated in the image below.
1.6.2 Screw holes
Place eight (8) screws into the holes indicated by circles to secure the
motherboard to the chassis.
Do not overtighten the screws! Doing so may damage the
motherboard.
Place this side
towards the rear
of the chassis
1-8
Chapter 1: Product introduction