Page 1
TOWEL WARMER KATH1260GY Instruction Manual To ensure proper operation of this device, please read this instruction manual carefully before using the device and keep it for further reference.
Page 2
GENERAL CARE AND SAFETY GUIDE YOUR SAFETY IS IMPORTANT TO US. PLEASE ENSURE YOU TAKE NOTE OF THE INSTRUCTIONS AND WARNINGS OUTLINED IN THIS MANUAL. When using electrical appliances, in order to reduce the risk of fire, electric shock, and/or injury to persons, basic safety precautions should always be followed, including: •...
Page 3
• This product is not equipped with a unit for controlling the room temperature. The product must not be used in small rooms inhabited by persons who cannot leave the room independently, unless continuous monitoring is guaranteed. • Always make sure the electrical socket is accessible and located adjacent to, but not above the appliance.
Page 4
• Never stand, sit on or hang on the Towel Warmer unit. • Never place your Towel Warmer inside a shower, sauna or steam room. • Never overload the Towel Warmer as it will cause the unit to become extremely hot and may result in a burn if touched. •...
Page 5
OVERVIEW OF THE TOWEL WARMER Plastic anchor Towel Holder Wall bracket LED indicator lights Screw (M4 x 27mm, pointy) Timer button Screw (M4 x 14mm, blunt) On/Off switch Screw (M4 x 16mm, pointy) Power cord with power plug Foot...
INSTALLATION WARNING: DO NOT connect the appliance to the mains voltage until it is fully installed in the desired location. Check that the installation location has access to a socket-outlet. If it does not, please contact a licensed electrician to arrange the installation of the socket outlet before continuing.
Page 7
B. Wall-mounting DANGER! Risk of death personal injury and damage to property! Read your drill’s operating and safety instructions carefully. DANGER! Risk of fatal injury! Avoid hitting electricity, gas or water pipes when drilling into the wall. If necessary, check with a cable detector before drilling into a wall.
Page 8
1. Mark the position of the drill holes on the wall (see above illustration). 2. Drill 4 holes (Ø6mm) into the wall. 3. Insert the plastic anchors (7) into the drill holes. 4. Turn 1 screw (M4 x 27mm, pointy) (9) into each plastic anchor (7).
Page 10
OPERATION OF THE TOWEL WARMER 1. Remove cable tie and unravel the power cord before operation. Ensure that the Towel Warmer has been securely and correctly installed. 2. Connect the power plug (5) to a suitable AC 220-240V~50Hz grounded power outlet. All LED indicator lights illuminate for 2 seconds once the power is connected correctly.
CARE AND CLEANING Always turn off the appliance and unplug it from power outlet before cleaning. Always ensure the product has cooled completely before cleaning. Clean the exterior surfaces of the Towel Warmer with a soft, slightly damp cloth. Never use any form of detergents or solvents to clean the appliance.
Page 12
2 Kendall Street, Williams Landing, Mulgrave Vic 3170 Vic, 3027 Customer Service: 1800 124 125 Customer Service: 1300 753 567 (Australia) or 0800 945 995 or via Customer Help at (New Zealand) or via target.com.au/help/contact-us Customer Help at kmart.com.au Cat. No. KATH1260GY December 2024...
Need help?
Do you have a question about the KATH1260GY and is the answer not in the manual?
Questions and answers