Homepage
— Enter the web address of the page you
•
want to display as the home page when you use this
access point.
4. After defining the settings, select
settings
to define the advanced settings or
the settings and exit.
Advanced internet access point
settings for packet data (GPRS)
Select
Menu
Tools
>
>
points.
After setting up a basic internet access point for packet data
(GPRS), select
Options
>
following advanced settings:
Network type
— Select
•
protocol type. The internet protocol defines how data is
transferred to and from your device.
Phone IP address
— Enter the IP address of your device.
•
Select
Automatic
to have the network provide the device
IP address. This setting is shown only if you select
Network type
> IPv4.
DNS address
— Select
•
Secondary DNS address
required by your service provider. Otherwise, the name
server addresses are provided automatically.
Proxy server address
•
server. Proxy servers are intermediate servers used by
some service providers between a browsing service and
its users. These servers may provide additional security
and speed up access to the service.
64
Options
>
Back
Settings
Connection
>
Advanced
settings, and define the
IPv4
or
IPv6
as the internet
Primary DNS address
and
and enter their IP addresses, if
— Enter the address of the proxy
Set up an access point for WLAN
manually
Advanced
1. Select
to save
Access
2. Select
access point, or select an existing access point from the
list and then
the access point as a basis for the new one.
3. Define the following settings.
Access
Connection name
>
•
connection.
Data bearer
•
WLAN network name
•
identifier (SSID), that is, the name that identifies the
specific WLAN, select
network from the WLANs in range, select
networks.
Network status
•
are connecting to is hidden or
WLAN network mode
•
Infrastructure, devices can communicate with each
other and with wired LAN devices through a WLAN
access point. If you select Ad-hoc, devices can send and
receive data directly with each other, and no WLAN
access point is needed.
WLAN security mode
•
security mode that is used in the WLAN access point. If
you select WEP (wired equivalent privacy), 802.1x, or
WPA/WPA2 (Wi-Fi protected access), you must also
configure the relevant additional settings.
Menu
Tools
Settings
>
>
points.
Options
New access point
>
Options
Duplicate access point
>
— Enter a descriptive name for the
— Select
Wireless
— To enter the service set
Enter
manually. To select the
— Select
Hidden
— If you select
— You must select the same
© 2010 Nokia. All rights reserved.
Connection
>
>
to create a new
to use
LAN.
Search for
if the network you
Public
if it is not hidden.