Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Torc T-15
Summary of Contents for Torc T-15
- Page 1 T- 1 5 U S E R ’ S M A N U A L www.torchelmets.com...
- Page 2 U S E R ’ S M A N U A L...
-
Page 3: Table Of Contents
ENGLISH Introduction Do’s and Don’ts T-15 Detail Wearing Your Helmet Sun visor operation Shield removal / installation Comfort liner removal / installation Care and Cleaning Storage Warranty... -
Page 4: Introduction #1
TORC helmet. You should also store this manual in a place where you can reference it if any questions arise. You should not use your new TORC helmet until you have read and fully understand the contents of this manual. - Page 5 is transmitted to the head and brain, and permanent injury or death may result. In addition, some head injuries are not caused by impacts. They are caused by other forces, like scrambling an egg just by shaking it. You do not have to destroy the shell to destroy the contents. Helmets cannot prevent this type of injury.
-
Page 6: Detail #3
18. Always ride with all padding installed properly in the helmet. 3. T-15 Details Depending on region of intended sale/use, this helmet meets or exceeds the homologation standard shown on the label located on the back of the helmet. Either DOT FMVSS 218 or ECE 1. - Page 7 WARNING-FIRMLY AND SECURELY FASTEN YOUR CHINSTRAP. Check your chinstrap for tightness occasionally as vibration or wind may loosen it. WARNING! The helmet chin strap must be securely fastened and snug under your chin and against your throat or the helmet may not stay on in an accident. If the helmet does not stay on, serious injury or death may result.
- Page 8 strap is tight periodically while you ride. If the chin strap has become lose, immediately stop and re-tighten the chin strap. WARNING! Do not wear a motorcycle helmet which does not fit right. Failure to follow this instruction could lead to serious personal injury or death. If you have purchased one of our full-face models, check the position of your eyes in relation to the eye opening of the helmet.
-
Page 9: Sun Visor Operation #5
cover less of the head provide less impact protection and may be more susceptible to helmet ejection, which can result in injury or death. It is also the helmet user’s responsibility to determine his or her ability to hear important traffic sounds while wearing and using this helmet. WARNING! Tinted lenses are not suitable for use at night. -
Page 10: Shield Removal / Installation #6
Shield removal / installation Release lever Align shield tabs hinge plate receiver shapes Raise shield to fully open position Pull down on lever located on hinge plate. While holding the lever down, work the shield outward from hinge plate. Repeat on other side. To install shield, Align shield tabs and hinge plate receiver shape. -
Page 11: Care And Cleaning #8
Use only mild soap and water to clean the interior and exterior of your helmet. Never decorate your helmet with paint, decals, stickers, or tape. Torc helmets should not be painted by anyone other than the manufacturer. Many helmet components can be seriously damaged by chemicals and/ or solvents contained in most paint or by careless handling during the repainting process. -
Page 12: Storage #9
Three Year Limited Warranty Subject to the following, Torc Helmets warrants to the original purchaser of each new T-15 purchased from Torc that the helmet when new is free of defective materials and workmanship. Any claim under this warranty must be made when the defect is first discovered, and in no event more than three years after date of purchase. - Page 13 THANKS FOR CHOOSING TORC HELMETS!
- Page 14 CORPORATE OFFICES & DISTRIBUTION CENTER: 957 S.LAWSON ST., CITY OF INDUSTRY, CA 91748 1(626)581-8811 www.TORCHELMETS.com facebook.com/OfficialTORCHelmets/ @torchelmets...
Need help?
Do you have a question about the T-15 and is the answer not in the manual?
Questions and answers