Waring IC20 Manual page 3

13. Check feeder chute for presence of foreign objects
before using.
14. Put this list in a safe place, do not discard.
SAVE THESE INSTRUCTIONS
HOW TO USE YOUR WARING
ICE CRUSHER
1. Place the 2.36-liter white bowl packed with the unit under
the bottom opening of ice crusher. Plug the unit in and set the
ON/OFF power switch to the ON position.
2. To begin crushing ice, drop cubes into feeder chute
opening on top of unit. Blades of crusher unit are self feeding.
DO NOT ATTEMPT TO PUSH CUBES INTO BLADES WITH
HAND OR IMPLEMENT.
3. If a large cube should become lodged in the crushing unit so that
blades cannot reach it, set power switch to the OFF position, and
unplug unit from outlet. Then pour warm water down through
feeder chute until lodged cube is melted or falls free. Plug unit
back into outlet, set the power switch to the ON position, and
resume feeding cubes through feeder chute.
4. NOTICE: Your ice crusher is equipped with a feature that allows
adjusting height of the unit to dispense ice directly into any size
container up to a maximum of 23 cm high. This is especially
beneficial for dispensing ice directly into a 621 ml or 1,419 ml
blender container. To adjust height see instructions.
TO CONVERT TO HIGHER POSITION
1. Lay unit face down on a flat surface so that the four housing
mounting screws face upward.
2. Remove 4 screws.
3. Reposition support columns so that the upper 4 holes align
with the 4 holes in the housing.
4. Replace screws.
APPROVED FOR
COMMERCIAL USE
COMMERCIAL
®
3