About CL5000 DND
The Do Not Disturb feature is activated by
pressing the Red 'Lock' button on the inside.
Once activated this prevents any User Code
from being able to unlock the lock. The only
codes that are able to unlock the lock are the
Master Code and Sub-Master Code.
If another User Code tries to unlock the lock
when Do Not Disturb is activated, the lock LEDs
will flash three times (•••) and the sounder will
beep three times. The lock will not unlock.
To deactivate from the inside press the
Blue 'Unlock' button or turn the handle.
Do Not Disturb can be bypassed and
deactivated from the outside by the Master
or the Sub-Master Code and depressing the
lever. Alternativel, inserting the override key and
depressing the lever will bypass and deactivate
Do Not Disturb.
For detailed instructions refer to the CL5000
Do Not Disturb Programming and Operating
Instructions:
codelockssupport.com/
Installation
Install the lock as per the installation
instructions, remembering to pass both
the power and ribbon cables through the
cable tube to the backplate (step 7 in the
Installation Guide).
Connect the ribbon cable and sensor cable
to the Accessory Panel/ Battery Cover plate
(The above should be completed during steps
14 + 15 in the Installation Guide)
The Basics
Each programming sequence starts with
the #Master Code or #Sub-Master Code.
The singular
•
blue dots throughout the
sequence represent an acceptance flash,
the keypad will illuminate blue to confirm
a correct input.
Need help?
Do you have a question about the CL5000 DND and is the answer not in the manual?