1. Manuals
  2. Brands
  3. NABO Manuals
  4. Dishwasher
  5. GSV 1046
  6. User manual

NABO GSV 1046 User Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
EN Dishwasher / User Manual
GSV 1046

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GSV 1046 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for NABO GSV 1046

Summary of Contents for NABO GSV 1046

  • Page 1 EN Dishwasher / User Manual GSV 1046...

  • Page 2: Table Of Contents

    CONTENTS 1.SAFETY INSTRUCTIONS ....................1 1.1. General Safety Warnings ....................1 1.2. Installation Warnings .....................2 1.3. During Use........................3 2.INSTALLATION ......................... 6 2.1. Machine Positioning .....................6 2.2. Water Connection ......................6 2.3. Water Inlet Hose ......................6 2.4. Drain Hose........................6 2.5. Electrical Connection ....................7 2.6.
  • Page 3 8.CLEANING AND MAINTENANCE ................. 19 8.1. Filters ...........................19 8.2. Spray Arms ........................19 8.3. Drain Pump ........................19 9.TROUBLESHOOTING ....................23...

  • Page 4: Safety Instructions

    1. SAFETY INSTRUCTIONS 1. General Safety Warnings • Read these instructions carefully before using your appliance and keep this manual for future reference. Please check the packaging of your machine before installation and the outer surface of the machine once the packaging has been removed. Do not operate the machine if it appears damaged or if the packaging has been opened.

  • Page 5: Installation Warnings

    2. Installation Warnings • Choose a suitable and safe place to install your machine. • Only original spare parts should be used with the machine. Unplug the machine before installation. Your machine must only be installed by an authorised service agent. Installation by anyone other than an authorised agent may cause your warranty to be void.

  • Page 6: During Use

    pressure exceeds 1 MPa, a pressure relief valve must be fitted between the connection. 3. During Usage • This machine is for domestic use only; do not use • it for other purposes. Commercial use will void the guarantee. Do not stand, sit or place loads on the open door of the dishwasher.
  • Page 7 the door for one minute after it has opened. For effective drying, keep the door open for 30 minutes after a programme has ended. Do not stand in front of the door after the auto-open signal sounds. In the case of a malfunction, repair should only be performed by an authorised service company, otherwise the warranty will be void.
  • Page 8 CE Declaration of Conformity We declare that our products meet the applicable European Directives, Decisions and Regulations and the requirements listed in the standards referenced. Disposal of your old machine The symbol on the product or on its packaging indicates that this product may not be treated as household waste.

  • Page 9: Installation

    2. INSTALLATION WARNING: Use the new water inlet 2.1. Machine positioning hose supplied with your machine, do not use an old machine’s hose. When positioning the machine, place it in an area where dishes can be easily loaded WARNING: Run water through the and unloaded.

  • Page 10: Electrical Connection

    2.6. Fitting the machine undercounter 2.5 Electrical connection If you wish to fit your machine undercounter, there must be sufficient space to do so and the wiring-plumbing must be suitable to do WARNING: Your machine is set to so (1). If the space under the countertop is operate at 220-240 V.
  • Page 11 Products Product’s Height (±2 mm) 820 mm 825 mm 835 mm A: If there is no felt on the top of the product; you should take into account this product’s height. B1: If there is felt on the top of the product with 2nd basket;...

  • Page 12: Technical Specifications

    3. TECHNICAL SPECIFICATIONS 3.2. Technical specifications 10 place Capacity settings Dimensions (mm) Height (mm) Width 450(mm) Depth 598(mm) Net weight 31,400 kg Operating 220-240V voltage / 50 Hz, frequency Total current 10(A) 3.1. General appearance 1. Worktop Total power 1900(W) 2.

  • Page 13: Before Using The Appliance

    4. BEFORE USING THE APPLIANCE 4.1. Preparing your dishwasher for first use • Make sure the electricity and supply water specifications match the values indicated in the installation instructions for the machine. • Remove all packaging material inside the machine. •...

  • Page 14: Test Strip

    4.4. Test strip Run water Keep the Shake the Wait Set the hardness level of through the strip in the strip. (1min.) your machine. tap (1min.) water (1sec) NOTE: The level is set to 3 as default. If the water is well water or has a hardness level above 90 dF, we recommend that you use filter and refinement devices.

  • Page 15: Filling The Detergent

    Continued use of too much detergent may washed clean. cause machine damage. If rinse aid dosage setting set too height, Using little detergent can result in poor you can see bluish layers on glass and cleaning and you can see whitish streaksin dishes.

  • Page 16: Loading Your Dishwasher

    5. LOADING YOUR WARNING: To avoid any possible DISHWASHER injuries, place long-handle and sharp- pointed knives with their sharp points facing down or horizontally on the baskets. For best results, follow these loading guidelines. Loading the household dishwasher up to the capacity indicated by the manufacturer will contribute to energy and water savings.
  • Page 17 Upper Basket Top basket Height adjustment Dish rack Turn the Rail Stop Clips, at the ends of the rails, to the sides to open them (as shown in Upper basket racks have two positions: the image below), then pull out and remove open (a) and closed (b).

  • Page 18: Alternative Basket Loads

    EN normatives and a softcopy of the manual, please send the model name and serial number to the following address: www.nabo.at Incorrect Loads Incorrect loading can cause poor washing and drying performance. Please follow the manufacturer's recommendations for a good performans result.

  • Page 19: Programme Table

    6. PROGRAMME TABLE Auto Intensive 65°C Program Hygiene Super 50’ Quick 30’ Prewash (Model Name: 70°C (Model depending) depending) Suitable Suitable Suitable Standard Suitable program for normally to rinse heavily lightly normally Suitable for Auto program soiled dishes soiled soiled soiled daily heavily soiled for heavily...

  • Page 20: The Control Panel

    7. THE CONTROL PANEL NOTE: If you decide not to start the selected programme, please see the "Changing a Programme" and "Cancelling a Programme" sections. NOTE: When there is insufficient 1. On/Off button softening salt, the Salt Lack Warning Indicator (ii) will illuminate to indicate the 2.

  • Page 21: Cancelling A Programme

    7.2 Cancelling a Programme Buzzer Sound Control Follow the steps below if you would like to To change the buzzer sound level, follow cancel a programme while in operation. the below steps: 1. Open the door and press Programme (2) and Delay (4) buttons simultaneously for 3 Open the door of your machine.

  • Page 22: Cleaning And Maintenance

    8. CLEANING AND To remove and clean the filter combination, turn it counter clockwise and remove it by MAINTENANCE lifting it upwards (1).Pull the coarse filter out of the micro filter (2).Then pull and remove Cleaning your dishwasher is important to the metal filter (3).Rinse the filter with lots of maintain the machine’s service life water until it is free of residue.

  • Page 23: Drain Pump

    8.3 Drain Pump Large food residues or foreign objects which were not captured by the filters may block the waste water pump. The rinsing water will then be above the filter. Warning Risk of cuts! When cleaning the waste water pump, ensure that you do not injure yourself on pieces of broken glass or pointed implements.

  • Page 24: Troubleshooting

    9. TROUBLESHOOTING FAULT POSSIBLE CAUSE TROUBLESHOOTING Your Dishwasher is not plugged in. Plug your Dishwasher in. Switch your Dishwasher on by pressing the Your Dishwasher is not switched on. On/Off button. Fuse blown. Check your indoor fuses. The programme does not start.
  • Page 25 FAULT POSSIBLE CAUSE TROUBLESHOOTING Use the correct amount of detergent, as Not enough detergent used. instructed in the programme table. Rinse aid dosage and/or water Increase rinse aid and/or water softener softener setting set too low. level. Whitish stains remains on dishes.
  • Page 26 AUTOMATIC FAULT WARNINGS AND WHAT TO DO TROUBLE POSSIBLE FAULT WHAT TO DO CODE Make sure the water inlet tap is open and water is flowing. Separate the inlet hose from the tap and clean the filter of Water inlet system failure the hose.
  • Page 27 Hersteller / Importeur: Baytronic Handels GmbH Harterfeldweg 4 | A-4481 Asten www.nabo.at 52253525 R35...

Table of Contents