E102 Series Enterprise Router Quick Start Guide Introduction This document provides a brief overview of the Cradlepoint E102 Series Enterprise Router discusses what’s inside the box and provides basic setup and installation instructions. The E102 router is paired with Cradlepoint NetCloud Service for SOHO.
E102 Series Enterprise Router Quick Start Guide 2.2 | SIM Card for Wireless Connectivity A wireless broadband data plan must be added to your Cradlepoint E102 router for wireless broadband connectivity. Wireless broadband data plans are available from network operators. The SIM card must be activated and provisioned by the network operator.
Page 5
E102 Series Enterprise Router Quick Start Guide [1] Cradlepoint E102 router [1] Power supply with interchangeable plugs (if applicable) [2] LTE antennas [1] Ethernet cable [1] SIM door screws [4] Rubber desk mount feet [1] Getting Started reference sheet [1] Safety, Regulatory, and Warranty guide Parts of the E102 router: 3.2 | STEP 2: Remove the SIM door.
E102 Series Enterprise Router Quick Start Guide 3.3 | STEP 3: Insert an activated SIM card. Insert an activated 2FF-sized SIM card into the SIM1 slot (contacts down, notch in). The SIM card clicks into place. Optionally, insert an activated 2FF-sized SIM into the SIM2 slot with the same orientation. 3.4 | STEP 4: Reinstall the SIM door Replace the SIM door and use the door screw to secure.
E102 Series Enterprise Router Quick Start Guide The E102 router may be mounted in a number of ways, including placed on a desk, affixed to a wall, or mounted on the ceiling. Refer to the following for best practices: 3.6.1 | DESKTOP Install the rubber feet (included) on the bottom of the router.
E102 Series Enterprise Router Quick Start Guide 3.9 | STEP 9: Activate the router in NetCloud Manager Activating your Cradlepoint router requires logging into your NetCloud Manager account. See Getting Started with NetCloud Manager for more information. Understanding LEDs The E102 router uses LED lights on the front panel to communicate various status conditions. Use the table below to verify the status of your router after the 1-minute bootup cycle.
Page 9
E102 Series Enterprise Router Quick Start Guide INDICATOR BEHAVIOR NCM STATE: Detects whether the device is able to connect to NCM. No Light = Unable to connect to NCM Solid White = Connected to NCM EMBEDDED MODEM STATE: Indicates connection status for the embedded (internal) modem.
E102 Series Enterprise Router Quick Start Guide INDICATOR BEHAVIOR CELLULAR HEALTH: Indicates the health of the primary cellular modem's signal. No Light = No cellular connection Solid Green = Cellular health is excellent/good Solid Yellow = Cellular health is fair Solid Red = Cellular health is poor Troubleshooting If the device takes longer than five minutes to connect to the Internet, log into the local UI of the...
E102 Series Enterprise Router Quick Start Guide Terms of Service Terms of Service &License Agreement Privacy Policy GDPR Privacy Policy Return to top Regulatory requirements Refer to the Safety, Regulatory, and Warranty guide included with your hardware for specific regulatory requirements. https://docs.cradlepoint.com/r/E102-Enterprise-Router-Quick-Start-Guide/Regulatory-requirements...
Need help?
Do you have a question about the Cradlepoint E102 Series and is the answer not in the manual?
Questions and answers