Page 1
Instruction Manual WASHLET Head Office TOTO Europe GmbH Zollhof 2, 40221 Düsseldorf Germany Tel:+49 (0)700 8686 0700 E-Mail: teu.information@toto.com TCF802E2G TCF802EAG TCF801EG TCF801EAG TCF804E2G TCF803EG You are advised to record the following information to allow quick service. Date of purchase :...
Table of Contents Auto energy saver / Auto energy saver+ ..20 Introduction Maintenance Reference Timer energy saver ........20 Auto open / close ON / OFF .......20 Safety Precautions ........4 Maintenance ..........40 What to Do? ..........57 Setting confirmation ........20 Before maintenance ........40 If the water does not flow due to a water Operational Precautions ......8 Auto flushing ON /OFF .......20...
Introduction Introduction Safety Precautions These precautions are important for safe usage. Be sure to follow them and use the product correctly. WARNING The following symbols are used to indicate important safety instructions for the use of the product. Symbol Meaning Do not install the product on moving vehicles such This appliance is not intended for use by persons as wheeled vehicles or boats.
Page 4
If the "Auto flushing" is activated, it would make the Use the new hose set included with this unit, consult the installer, seller, or TOTO customer wastewater in the bowl unit overflow and may result equipment. Do not reuse an old hose set.
Introduction Introduction Operational Precautions For prevention of damage For prevention of malfunctions Do not use the product with the toilet lid removed. About the built-in seat sensor Wipe plastic areas such as the main unit and Do not block the body sensor or the remote control Do not expose to direct sunlight.
Introduction Introduction Parts Names B: Left side of the main unit C: Right side of the main unit Product name, part no., etc. Power switch ( Page 13) Soft light Deodorizing filter ( Page 43) Toilet lid Main unit removal button Water filter drain valve ( ...
Introduction Introduction Preparation If the remote control is secured to prevent theft If the light is off , but the power switch is "ON" Using the Product for Turn on the power Hold the remote control and loosen the hanger Switch "Power"...
Introduction Operation Preparation Basic Operations Floor-mounted bowl unit Mechanism of Auto 2. A s you sit Remove the main unit. ( Page 44 Step 1, 2) Functions Fully open the shutoff valve. Deodorizer "EWATER+" is used automatically to clean the wand and bowl unit.
Operation Operation Basic Operations Auto wand CLEAN 4. What is meant by "EWATER+" ? A s you move away Only when the washing functions are used. This water containing hypochlorous acid generated from chloride ions in tap water, is widely used for After about 25 seconds cleaning and disinfecting items such as food, utensils Auto fl...
Operation Operation Basic Operations Using the Remote Control Pulsating washing Flushing Washes with the water pressure Full fl ush pulsating between soft and strong. Performs a full flush. Light fl ush Oscillating washing Performs a light flush. The wand moves back and forth to washes your rear thoroughly.
Operation Operation Basic Operations Using the Remote Control (Continued) Remote control back side How to remove the remote control ( Page 12) Operate the controls on the remote control; a beep sounds when the main unit receives the signal. This section is an overview of the settings that can be configured with the remote control.
Operation Operation Temperature Adjustment Note: The "Drying" cannot be turned "OFF". Warm Water, If the button is not pressed for about 10 seconds, the "Tem- Press the button selected in step repeatedly Press the button selected in step repeatedly perature adjustment" LED will go off , but the setting will be until a desired temperature level illuminates.
Operation Operation Changing Settings Setting buttons ( Pages 28–39) Setting List Setting with buttons on the front of the remote control Press the button indicated in step 1 for approxi- Available Settings Setting Types Applicable Models mately 10 seconds or longer to enter setting Bold: Initial settings mode.
Operation Operation Changing Settings Timer energy saver Timer energy saver and The energy saver features Auto energy saver / You want to save energy only for a preset duration Auto energy saver+ "Auto energy saver", "Auto energy saver+" or "Timer energy of time.
Operation Operation Changing Settings How to Set Auto energy saver+ Timer energy saver Auto fl ushing Set the "Timer energy saver" at the time you Set whether or not to clean the bowl unit want to start it. automatically Auto energy saver Example: To save energy from 1 am to 7 am Press "Auto energy saver"...
Operation Operation Changing Settings "Auto flush lid closed" does not work if "Auto flushing" Auto fl ush delay Auto fl ush lid closed About "Auto flush lid closed"… and "Auto open / close" are set as below: (Except when using the flush buttons on the remote control) About 10 seconds after you stand up or move away if Change the amount of time before the toilet Set whether or not to close the toilet lid...
Operation Operation Changing Settings Auto open / close Auto close delay Auto open delay Seat/lid Set whether or not to open and close the toilet Change the amount of time before the lid/seat Change the time period till automatic opening Automatically open and close the toilet lid/ lid automatically closes automatically...
Operation Operation Changing Settings Auto wand CLEAN Auto bowl CLEAN Deodorizer Auto power deodorizer Set whether or not to clean the wand Set whether or not to spray mist in the bowl Set whether or not to deodorize automatically Set whether or not to power deodorize automatically unit automatically after sitting on the toilet seat...
Operation Operation Changing Settings Soft light Bowl light CLEAN indicator Beep sound Set whether or not to use the soft light Set whether or not to use the light inside the Set whether or not to light up the CLEAN Set whether or not to make a beep sound bowl unit indicator...
Operation Operation Changing Settings Pressure / position setting Personal setting Registering Personal Settings Set whether or not to use the personal setting Register your preferred wand position, etc. Set whether or not to keep your favorite pressure and position settings Press and hold both the "Stop"...
Maintenance Maintenance Maintenance Attention Before maintenance To turn the power "OFF" Main unit This product is an electric appliance. Be careful not to Remove the cover on the left side of the main unit, and let water seep inside or leave detergent in the gap WARNING flip the power switch to "OFF".
Maintenance Maintenance Maintenance Wand Deodorizing Filter Manual Spray Wipe with a soft cloth that has been soaked in water and wrung out thoroughly. Approximately once a month EWATER+ mist can be sprayed to separate dirt from the surface for maintenance. ...
Maintenance Maintenance Maintenance Gap between the Main Unit Clean the top of the bowl unit and the bottom of Mount the main unit. and Bowl Unit the main unit. Lift the main unit, then lower it straight down while Wipe with a soft cloth soaked in a diluted, neutral threading the power cord and water supply hose You can remove the main unit to clean the top of the kitchen detergent.
Maintenance Maintenance Maintenance Gap between the Main Unit Wipe with a soft cloth that has been soaked in and the Toilet Lid water and wrung out thoroughly. The toilet lid can be removed for thorough cleaning. Reinstall the toilet lid. Insert C and then D into the pins.
Maintenance Maintenance Maintenance Descaling agent specifi ed by TOTO 100% citric acid (for consumption or cleaning) Descaling Agent Descaling If you wish to use other agents, please contact us on Do not use descaling agents that contain organic Usable descaling agents If you think the water pressure has weakened the phone number on the back of this manual.
Maintenance Maintenance Maintenance Descaling mode (1st time) Steps Descaling mode Set descaling mode. Insert funnel and pour diluted agent. Dilute agent with water. Beaker Note: Washing modes (such as rear and front) cannot be Funnel ( Please see How to dilute on pages 48, 49.) used from step until the second descaling operation in step is complete.
Page 27
Maintenance Maintenance Maintenance Descaling mode (2nd time) Steps Descaling mode (Continued) Perform descaling. Dilute agent with water. Perform descaling. ( Please see How to dilute on pages 48, 49.) Press and hold both the "Stop" Check button and "Water pressure Pour diluted agent.
Descale the filter using the descaling agent specified sides of the spray nozzle and slide it. spray nozzle along the guide and push it in. by TOTO or 100% citric acid (for consumption or CAUTION Install correctly until a click sound is heard.
If you cannot operate with Descale the removed spray nozzle using the descaling the remote control agent specified by TOTO or 100% citric acid (for con- fl ow due to a water sumption or cleaning), then wash it with water.
Descale the filter using the descaling agent specified Before starting to work, set “Auto fl ushing” ( Page by TOTO or 100% citric acid (for consumption or Do not remove the drain plug with water supply 29) and "Auto open/close" ( Page 32) to "OFF".
Descale the filter using the descaling agent specified The water needs to be resupplied. ( See right) by TOTO or 100% citric acid (for consumption or If the power is not on, turn the power ON. Turn the power "OFF". ( Page 14) cleaning), then wash it with water.
Remote control transmitter If the above symptom reappears There may be a malfunction. Consult with TOTO Service. ( see contact information on the back cover) Please check fi rst (A–C) The wand extends but the Has a water failure occurred? washing water does not come ...
Reference Reference Troubleshooting Rear Washing, Front Washing and Wand (Continued) The bowl unit does not clean During descaling "Auto flushing" is not performed during descaling. ( Pages 50–53) automatically or the timing is delayed Trouble Please check When sitting on the toilet seat, is there a toilet seat cover or clothing on the seat sensor? (Auto fl...
Reference Reference Troubleshooting Toilet Seat and Toilet Lid (Auto open/close) (Continued) Toilet Seat and Toilet Lid Trouble Please check Trouble Please check The toilet lid opens on its own Is the body sensor directly exposed to sunlight? The toilet seat is cold Is the toilet seat temperature set to "OFF"...
If any nuts in a connection are loose, firmly tighten them with a tool such as a mon- key wrench. ing connections If the water leak does not stop, close the shutoff valve and consult with TOTO Service ( see contact information on the back cover). The main unit makes a sound When entering the bathroom If "Auto bowl CLEAN"...
When there is a rack or cabinet installed on the wall behind the main unit When an inverter lighting system is used Change the position of the remote control and try again. *1 At 0.20 MPa (dynamic) water pressure *2 Temperature around the warm air outlet measured by TOTO.
Service Center authorised by TOTO Continued use after malfunction occurs or use when its life-time is of purchase. This guarantee only applies to ultimate or contact TOTO itself. Notification of the defect is to be expired may deteriorate the electric components, producing smoke consumers.
Need help?
Do you have a question about the WASHLET TCF802E2G and is the answer not in the manual?
Questions and answers