KwikBoost EdgePower 13797450 Instructions

In the Box:
Clamp-On
Desktop Charging Station
1
Open Clamp-On Desktop Station
clamp by loosening 8 mm bolt.
3
Tighten bolt until clamp fits snugly on desk.
IMPORTANT: Do not over-tighten bolt.
CHARGING STATION
13797450
Ships / Sold Separately:
8 mm Hex Wrench
2
Test clamp fit by sliding clamp over edge of desk or table
Ensure outer edge of desk fully reaches inner edge of clamp.
Ensure there is adequate clearance to insert and remove
Rechargeable Battery.
4
Insert Rechargeable Battery into Clamp-On Desktop Charging Station.
IMPORTANT: Battery must be fully charged before first use.
Rechargeable Battery
A B
INSTRUCTIONS
Tools Required:
8mm Hex Wrench
Battery Charger Options
.