KwikBoost EdgePower KBEP-CGR Instructions

In the Box:
Clamp-On
Desktop Charging Unit
1
Open Clamp-On Desktop Charging Unit
clamp by loosening 8 mm bolt.
3
Tighten bolt until clamp fits snugly on desk.
IMPORTANT: Do not over-tighten bolt.
CLAMP ON DESKTOP
CHARGING UNIT
KBEP CGR
Ships / Sold Separately:
8 mm Hex Wrench
2
Test clamp fit by sliding clamp over edge of desk or table
Ensure outer edge of desk fully reaches inner edge of clamp.
Ensure there is adequate clearance to insert and remove
Rechargeable Battery.
4
Insert Rechargeable Battery into Clamp-On Desktop Charging Unit.
IMPORTANT: Battery must be fully charged before first use.
Rechargeable Battery
A B
INSTRUCTIONS
Tools Required:
8mm Hex Wrench
Battery Charging Options
.