Download Print this page
Kohler HiRise K-7338-4-BS Installation Manual
Kohler HiRise K-7338-4-BS Installation Manual

Kohler HiRise K-7338-4-BS Installation Manual

Wall-mount kitchen faucet

Advertisement

Quick Links

Installation Guide
Wall-Mount Kitchen Faucet
K-7338
M product numbers are for Mexico (i.e. K-12345M)
Los números de productos seguidos de
M corresponden a México (Ej.
K-12345M)
Français, page "Français-1"
Español, página "Español-1"
1069114-2-A

Advertisement

loading
Need help?

Need help?

Do you have a question about the HiRise K-7338-4-BS and is the answer not in the manual?

Questions and answers

Summary of Contents for Kohler HiRise K-7338-4-BS

  • Page 1 Installation Guide Wall-Mount Kitchen Faucet K-7338 M product numbers are for Mexico (i.e. K-12345M) Los números de productos seguidos de M corresponden a México (Ej. K-12345M) Français, page “Français-1” Español, página “Español-1” 1069114-2-A...
  • Page 2: Tools And Materials

    Select pipe nipples long enough to protrude through the finished wall. Do not use petroleum based products on this product. Kohler Co. reserves the right to make revisions in the design of faucets without notice, as specified within the Price Book. 1069114-2-A...
  • Page 3 Hand tighten the two wall union shanks onto to each pipe nipple. NOTE: Do not damage the O-rings or the finish on the faucet assembly when tightening the union nuts. Secure the faucet assembly to the wall shanks with the attached union nuts. Kohler Co. 1069114-2-A...
  • Page 4 Remove the faucet assembly and the wall shanks. Place the faucet assembly in its original packaging to prevent damage. Site Checkout Flush the water lines. Cap the pipe nipples and check for leaks at the elbows. Complete the finished wall. 1069114-2-A Kohler Co.
  • Page 5 Thread the wall shanks to the pipe nipples, then tighten with a 3/8″ hex wrench. For each wall shank, ensure the distance from the end of the wall shank to the finished wall is equal. Adjust if needed. Kohler Co. 1069114-2-A...
  • Page 6 finish on the union nuts when using the strap wrench. Using a strap wrench, tighten the union nuts to secure the faucet assembly to the wall union shanks. Verify the handles are in the OFF position, as shown. 1069114-2-A Kohler Co.
  • Page 7: Installation Checkout

    Turn both handles to the ON position to run water through the faucet. Allow the water to run through the spout to remove any debris. Turn both handles to the OFF position. Remove any debris from the aerator and reinstall. Kohler Co. 1069114-2-A...

This manual is also suitable for:

Hirise k-7338-4-s