Related Manuals for Hunter REVOLUTIONS Sprite
Summary of Contents for Hunter REVOLUTIONS Sprite
- Page 1 Sprite Owner’s Manual Assembly Installation Operation • • • Product: Ceiling Fan Trademark: Revolutions Quantity: 1 Piece Electrical Rating: 220V ~ 50/60Hz Weight ±2 lbs: 10 lbs (4.5 kg) ME018-01 r121815...
- Page 2 - To reduce the risk of fire, electrical shock, or motor damage, use only Hunter Speed Controls. w.4 - To reduce the risk of personal injury, do not bend the blade brackets when installing the blade brackets, balancing the blades, or cleaning the fan.
-
Page 3: Tools And Materials Required
Unpacking the Fan Unpack your fan and check the contents. Do not discard the box. If warranty replacement or repair is ever necessary, the fan should be returned in its original packaging. Remove all parts and hardware. Do not lay the motor housing on its side; the decorative casing may shift. Tools and Materials Required •... -
Page 4: Install Mounting Bracket
Assessing the Installation Location CAUTION ,8 Meters from blade tip To reduce the risk of injury to to nearest wall persons, install fan so that the blade or obstruction 2,1 Meters is at least 2,1 m above the floor. from bottom edge of blade to the floor Install Mounting Bracket... - Page 5 Installing the Fan Select Type of Installation Standard Low Profile This method is preferred if the ceiling is sloped, This method is preferred if maximum vaulted, or if the ceiling is extra high and headroom is required. The celing must not requires the use of a downrod.
-
Page 6: Low Profile
2. Tighten the two down rod setscrews. Some models have locknuts for the setscrew to ensure the setscrew is fully seated against the down rod. It is necessary to back off the locknut until it contacts the setscrew head prior to tightening the setscrew. When the setscrew is tightened against the downrod, the locknut should then be tightened against the connector yoke. -
Page 7: Wiring The Fan
Wiring the Fan Ensure electricity is switched off at the main power supply before installing or maintaining this fitting. The ceiling fan can be installed to operate in several different modes: 1. Fan controlled by pull switch, light controlled by pull switch. 2. -
Page 8: Operating The Fan
Installing the Bulb and Glass 1. Insert a 60W max BC bulb or a 14W energy saving bulb into the lampholder. Do not use a higher wattage lamp. 2. Secure the lamp shade (Fig. 7a) to the switch housing. Fig. 7a Operating the Fan 1. - Page 9 Reversing the Fan Turn the fan off and let the blades stop before changing the direction of the air flow. Engage the reverse switch to change the blade direction. In warm weather, ceiling fans work In cool weather, set your fan to best by blowing air downward draw air upward (clockwise) to (counterclockwise) providing the...
-
Page 10: Troubleshooting
Troubleshooting FAN WILL NOT START: 1. Check all fuses or circuit breakers. Replace if missing. 2. Turn off electrical power and check all wire connections to fan and in the wall control. FAN IS NOISY 1. Use of standard light rheostat or continuously variable fan speed wall control will always cause harmonic distortions or a huming noise.
Need help?
Do you have a question about the REVOLUTIONS Sprite and is the answer not in the manual?
Questions and answers