Advertisement
Quick Links
Advertisement
Related Manuals for Sparklan WUBR508N-D
Summary of Contents for Sparklan WUBR508N-D
- Page 1 WiFi Network card Quick Installiaton Guide Version 1.0...
- Page 2 Contents 1. Package Contents ......................3 2. WiFi Network Card Installation ..................4 3. Connect to Wireless Access Point .................. 9 ...
- Page 3 Copyright statement No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, whether electronic, mechanical, photocopying, recording, or otherwise without the prior writing of the publisher. April 2012...
-
Page 4: Package Contents
1. Package Contents Before you starting to use this WiFi network card, please check if there’s anything missing in the package, and contact your dealer of purchase to claim for missing items: Package Contents Please make sure you have the following in the box: ... - Page 5 2. WiFi Network Card Installation 1. Insert the WiFi network card into an empty USB 2.0 port of your computer. Never use force to insert the card, if you feel it’s stuck, flip the card over and try again.
- Page 6 2. If he following message appear on your computer, click ‘Cancel’. 3. Insert the Driver CD then wait for the Autorun prompt.
- Page 7 4. If Autorun does not work, please browse the CD content and double click the “Setup.exe”. 5. Click “Next” and then follow the instructions on the screen to continue the installation.
- Page 9 6. When you see this message, please click “Finish” to complete the driver installation process.
-
Page 10: Connect To Wireless Access Point
3. Connect to Wireless Access Point 1. After installation is complete, a small Ralink icon appears in the notifications area of the taskbar. You can double click it to maximize the RaUI dialog box. 2. When starting RaUI, the system will connect to the AP with best signal strength without setting a profile or matching a profile setting. - Page 11 3. You could follow the steps to connect to the AP which you want to connect (Example to Configure Connection with WPA2-PSK). a. Select the AP and click “Connect” icon b. Authentication/Encryption function appears.
- Page 12 c. Select WPA2-PSK as the Authentication Type. Select TKIP or AES encryption. Enter the WPA Pre-Shared Key. d. Click "OK". Be careful, if the WPA Pre-Shared Key entered is not correct, you won’t be able to exchange any data frames, even though the AP can be connected.
- Page 13 4. At last, if you want to know more using method of RaUI, you could refer to the help file by click the question mark at the top right corner of RaUI to open it.
-
Page 14: Federal Communication Commission Interference Statement
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio...
Need help?
Do you have a question about the WUBR508N-D and is the answer not in the manual?
Questions and answers