Table of Contents
Advertisement
Installation: Rear-Facing
Lap-Shoulder Belt Installation
• Figure A illustrates a rear-facing, lap-shoulder
belt installation.
• When not in use, always store the LATCH
connectors in the storage slots. See page 33.
1 Recline the child seat then place it rear-facing
on the vehicle seat.
the recline position when installed rear-facing.
See Recline Adjustment on page 33
2 Lift the cover to open the rear-facing lock-off
farthest from where the vehicle belt will be
buckled (Fig. B).
3 Pull the vehicle belt out, then pass it under the
LATCH bar and through the rear-facing belt
slot (Fig. C).
• The vehicle belt can be routed over or under
the cover.
4 Route the vehicle belt across seat then
through the opposite rear-facing belt slot and
under the LATCH bar.
IMPORTANT: The vehicle belt must rest behind the
child seat buckle strap.
5 Verify that the vehicle belt is not twisted, then
buckle (Fig. D).
6 Push the child seat firmly into the vehicle seat
while removing slack first from the lap portion
of the vehicle belt, then the shoulder portion
(Fig. E).
18
This child seat must be in
.
A
b
C
d
Hide quick links:
Advertisement
Table of Contents
