CMD Miro Installation And Care Manual

Miro
Dimensions
Designed to fit onto desks with 16-27mm
thickness with the included clamp.
Mounting the base to the desk
2
1
Base tab Notch
If not already in place, Place the base near the
fit the 180° - stop ring edge of the desk and
with the notch opposite offer up the C-clamp as
the base tab. shown.
4 5
Place the clamp cover The base is now
over the base with the secured in place and
cut-out facing the desk ready for the arm to be
edge. installed.
Part No: 134330 Issue No: 005
3
Ensure 2x clamp screws
locate in holes in the
base and tighten fully.
Tighten both evenly.
Installation, user and care guide
Contents
x1 x1
4mm 5mm
VESA install adjust arm
x4 clamp x1 spring
screws
Pre-tensioning the arm
6 7
Use the 5mm Allen key Arrow shows direction
to turn the adjuster at to turn the adjuster. '+'
the base of the lower for heavier monitors. '-'
arm as shown. for lighter monitors.
9 10
Turn the adjuster anti- Turn the adjuster
clockwise to suit lower clockwise to suit
weight monitors. Do heavier monitors upto a
not adjust past 'STOP'. max. weight of 9kg.
Installing the arm
12 13
*IMPORTANT*
Lower the arm onto the Guide the lug on the
installed base on the side of the arm into the
desk. slot on the 180°- stop
ring as shown.
Installing the head onto the monitor
15
Align the VESA holes on the head with those on the monitor, either 75mm
or 100mm spacing. Fix in place with the supplied fixing screws. The
monitor is now ready to install onto the arm.
x1 x1 x1
x1
(if monitor weight is known)
8
The window on the
lower arm indicates the
monitor weight setting,
from 2-9 kg.
11
Weight in kg
Ensure to align the
desired weight setting
centrally in the window.
14
The arm is now secured
in place and ready for
the head and monitor
to be installed.
x1