Figures and illustrations in this manual are provided for reference only and may differ from actual product appearance. Parts of the software function changes with the system upgrade. If you encountered difficulty when setting up your TV, we suggest you refer to the troubleshooting tips in the User Manual or the E-Manual.
Page 3
Declaration Any content and service accessed through this device, while only intended for individual non- commercial use, shall be the property of the applicable third party and subject to protection by regulations and laws on copyright, patent, trademark and other intellectual property rights. No part of such content and service may be modified, duplicated, published, uploaded, distributed, translated, marketed, or used to make and distribute products derived from it without the prior permission of the content owner or service provider.
Page 4
Safeguards Warning Please read the following safeguards for Stability Hazard your TV and retain for future reference. A television set may fall, causing serious A l w a y s f o l l o w a l l w a r n i n g s a n d personal injury or death.
Page 5
the manufacturer or salesperson. circuits, or where it can fall into such power lines or circuits. Where installing 7. Ventilation an outside antenna system, extreme care Slots and openings in the cabinet are should be taken to keep from touching provided for ventilation, to ensure reliable such power lines or circuits as contact operation of the TV and to protect it from...
Page 6
Adjust only those controls that are Do not mix and use new batteries with old batteries, or batteries with covered by the operating instructions different types. Do not expose as an improper adjustment of other batteries to heat such as direct controls may result in damage and sunlight or fire.
Installation CAUTION Be sure to disconnect the AC power cord before removing a base stand or installing wall mount brackets. The display on your TV is fragile. Make sure the TV screen is not scratched or damaged by hard objects or from pressure. After the installation is complete, make sure the TV is steady on a table or firmly attached to a wall mount, before removing all protective film, if any.
Page 8
Ensure Part B is under Part A when pushing forward. Part A Part B Apply gentle downward pressure while pushing it forward with two hands. Push until the base cover reaches the stand columns, and make sure there is no gap between them. Stand Columns Base Cover For 85"...
5. Use your hands to pinch the base cover and base stands together tightly until you heard a snap sound. 6. Move your TV to a flat surface and you can tidy the cable into cable organizer on the base stands. Installing the wall mount bracket CAUTION When mounting the TV on a wall, follow instructions provided with the wall mount bracket.
Page 10
Installing the P-Clip Please place the TV on a horizontally stable surface, and then use P-Clip to connect the TV and the wall or pillar. (Marked in the illustration below.) For 55"/65"/75" 1. Fix part of P-Clip to the screw hole on the back of TV set with a M6×12 screw. 2.
TV Front and Rear Light sensor AC INPUT Power indicator / Voice indicator Power button (Standby/Source) Built-in microphone control button Item Description Power indicator The light is white in standby mode. Press the button to turn the TV on. Press it again to bring Power button up the control menu and move the focus between different (Standby/Source)
Connection Terminals Connect an outdoor VHF/UHF antenna or cable. HDMI Connect an HDMI cable from an external equipment. Connect an HDMI cable from an external digital audio system. HDMI Please note that it works only when the TV is connected to the (eARC) audio receiver that supports the eARC function.
Page 13
Network Wired setup Connect your TV to your network by connecting the LAN port on the back of your TV to an external modem or router using a LAN (Ethernet/Cat 5) cable. See the illustration below. · We recommend you to use a modem or router that supports Dynamic Host Configuration Protocol (DHCP).
Remote Control Buttons of remote control Power on/Standby Select input sources Quick access buttons to apps Custom button to launch contents quickly Quick setup Playpad keys Navigation buttons OK / Display the on-screen keyboard (Up/Down/Left/Right) Under the Menu or App, Exit the menu or exit the application return to the previous place...
Charging the Remote Control You can charge the remote by exposing the solar cell to light or using a USB type-C cable(not provided). When charging by type-C port, the red indicator will blink. When fully charged, the indicator will stop solar cell blinking first and then turn off.
Specifications Features, appearance and specifications are subject to change without notice. 55" 65" Item Without Stand 1226 × 713 × 77 1446 × 837 × 75 (W × H × D) Dimension (mm) With Stand 1226 × 773 × 288 1446 ×...
Other Information Disposal of Used Electrical & Electronic Equipment Packaging and electrical goods should be recycled appropriately, and not treated as household waste. Please dispose of this equipment at your applicable collection point for the recycling of electrical & electronic equipment waste. By ensuring the correct disposal of this product, you will help prevent potentially hazardous to the environment and to human health, which could otherwise be caused by unsuitable waste handling of this product.
Page 18
What is Freeview Plus? Freeview Plus is a new television service delivered via broadband providing a state of the art Electronic Program Guide (EPG) and seamless access to catch-up TV across the free-to-air networks with the simple press of a button. How does it work? First ensure the TV is connected to internet and an antenna system.
Need help?
Do you have a question about the 55U7QAU and is the answer not in the manual?
Questions and answers